ASM_Nozzles_EN.pdf - 第10页
1 - 6 www.asm-smt.com Nozzle series 28xx: These nozzles are used on the SIPLACE CPP . All nozzles in this series have a 4-digit number code on the in- side. The letter I or E in the allocated GF name marks the use of a h…
1 - 5
www.asm-smt.com
Nozzle series 1xxx:
These nozzles are used on the SIPLACE C&P20A/M.
All nozzles in this series have a 4-digit number code on the
top outer side.
Examples:
Nozzle series 20xx:
These nozzles are used on the SIPLACE CPP.
All nozzles in this series have a 4-digit number code on the
top outer side.
The letter I or E in the allocated GF name marks the use of a
head with an i
nternal or external camera.
Examples:
1 - 6
www.asm-smt.com
Nozzle series 28xx:
These nozzles are used on the SIPLACE CPP.
All nozzles in this series have a 4-digit number code on the in-
side.
The letter I or E in the allocated GF name marks the use of a
head with an i
nternal or external camera.
Examples:
Nozzle series 4xxx/6xxx:
These nozzles are used on the SIPLACE C&P20P/M2/P2.
All nozzles in this series have a 4-digit number code on the
outer and top side.
NOTICE!
4xx and 6xx nozzles are of identical design and can
be used accordingly.
For example, a 4004 nozzle is mechanically identical to
a 6004 nozzle.
.
Examples:
1 - 7
www.asm-smt.com
0° Description of Components
In order to work with component shapes which have uniform definitions, standard components are described using four
specific rules. This is known as the "0° description" position, which allows you to precisely define the pickup angle during
placement.
To describe the component shape of a component, the dimensions should always be taken from the corresponding data
sheet. Make sure that the component is always described as viewed from above.
The display area of the Component Shape Editor always shows the 0° description of the component. This zero degree
origin of the coordinate system is always shown in the center of the CS Editor display area. The X axis points to the right
and the Y axis points upwards. The center of the component generally corresponds to the origin of the coordinate system.
Rule 1 defines the alignment of the component sides in the X or Y directions.
Rule 1: A nozzle with rectangular suction surface is aligned with its longer side along the X axis. The component
X axis is parallel to the nozzle X axis, when the nozzle picks up the component properly.
When picking up a component, the component X axis always points in the same direction as the long side of the nozzle
(exception: special nozzles with 90° rotation/asymmetrical nozzles in wider angles, specific to certain applications).