NPM Calibration Manual-En.pdf - 第7页
NPM Maint en anc e E di ti on 9.2 Head Cam er a X Y O rigi n Page 9-6 EJM9BE-M B-09M-21 7 Check that it i s successfu ll y com pl ete. ∗ Perf orm steps 3–7 f or also the other t able. 8 Press [PlaneCorrX Y]. • W hen exit…
NPM
Maintenance Edition
9.2 Head Camera XY Origin
EJM9BE-MB-09M-21 Page 9-5
9.2 Head Camera XY Origin
This procedure is common to 12-nozzle, 8-nozzle, and 2-nozzle heads.
1
Press .
2
Press [H-camera XY org].
3
Select a table.
∗
Select the target table for calibration.
4
Press + [Camera angle].
•
The calibration is carried out.
5
Check that it is successfully complete.
6
Press + [XY Origin Camera
scale].
•
The calibration is carried out.
UnitCalibAxisOrigin-02E00
6
5
UnitCalibAxisOrigin-01E00
1
2
UnitCalibAxisOrigin-01E00
3
4
NPM
Maintenance Edition
9.2 Head Camera XY Origin
Page 9-6 EJM9BE-MB-09M-21
7
Check that it is successfully complete.
∗
Perform steps 3–7 for also the other table.
8
Press [PlaneCorrXY].
•
When exiting this screen to the other one, you
are always prompted to save the data.
∗
To save the data obtained by the calibration,
press [Yes].
•
If you press [No], the return-to-origin process
is carried out and the data obtained by the
calibration are lost.
•
After the above operation, the next screen is
displayed.
UnitCalibAxisOrigin-03E00
7
UnitCalibAxisOrigin-04E00
8
NPM
Maintenance Edition
9.3 Plane Compensation XY
EJM9BE-MB-09M-21 Page 9-7
9.3 Plane Compensation XY
This procedure is common to 12-nozzle, 8-nozzle, and 2-nozzle heads.
Since the plane-compensation jig is loaded from the upstream process and unloaded to the downstream
process, adjust the width of the upstream and downstream transfer conveyors to that of the
plane-compensation jig.
Remove all support-pins before performing calibration.
For the dual conveyor type, put the conveyor into single lane mode.
( Steps 1 through 7 in “10.5 Single Lane Mode Selection on the Dual Conveyor”.
It is not necessary to attach the board support blocks (for single lane mode).)
1
Set the plane-compensation jig to the
upstream process.
2
Press .
3
Press [PlaneCorrXY].
∗
Check that no PCBs remain in the machine.
4
Press + [Jig carry in].
•
An error message is displayed if there are
remaining PCBs in the machine.
∗
After removing the remaining PCBs, press
[Jig carry in] again.
5
Press + [Run].
•
The conveyor width is adjusted automatically.
Load the plane-compensation jig.
UnitCalibAxisSurface-02E00
5
UnitCalibAxisSurface-01E00
2
3
4