9018-07128.pdf.pdf - 第6页
6 Medalist i3070 Series 5i Uncrating the System Uncrating the System Uncrating Procedure 1 With one person on each side of th e front wall, release the latches and remo ve the front wall fr om the crate. 2 Remo ve the bo…
Uncrating the System
Medalist i3070 Series 5i Uncrating the System 5
Handling Guidelines
Forklift Requirements
A forklift with tines of at least 1530 mm (54”) and capable of lifting at
least 1500 kg (5000 lb) at a load centre of 1140 mm (45”) is needed to
unload and move the system.
Other transportation can be used as long as the full weight of the main
unit is fully and properly supported.
General Handling Guidelines
• Do not carry or lift the system by its doors or any openings in the
covers.
• Always handle the system at the base.
• Care must be taken to prevent damage to the system through rough
handling.
• It is recommended that the forklift be positioned at the rear of the
system. Insert the fork at the base of the system, as indicated by the
labels (Figure 1). Ensure that the system is as far as possible from the
end of the fork.
Figure 1 Forklift Positioning
Failure to meet the above requirements could result in serious injury
to personnel and/or damage to the Medalist i3070 Series 5i system.
WARNING
AS FAR AS
POSSIBLE
AS CLOSE
AS POSSIBLE
6 Medalist i3070 Series 5i Uncrating the System
Uncrating the System
Uncrating Procedure
1 With one person on each side of the front wall, release the latches and
remove the front wall from the crate.
2 Remove the bolts along the bottom of the rear and side walls.
Crates are custom built for individual systems and may have slight differences in how they
are assembled. For instance, the front wall may be attached with ¼-turn draw latches or by
bolts. Another variation is how the system is secured to the base. It may be secured using
poly straps or braced by wooden blocks that are attached by screws from the side walls.
NOTE
At least two people are required for the next step.
Front view of crated system on pallet
Latches
Front wall removed
Accessories
Box
Rear and side walls
Bolts
WARNING
Uncrating the System
Medalist i3070 Series 5i Uncrating the System 7
3 Remove the tri- wall assembly by sliding it back and away from the
pallet.
4 If the system is secured with poly straps, cut them at both sides of the
system.
5 Release the bolts to remove the following from the pallet:
a Front support
b Front stopper
c Back stopper
Poly straps securing the system to the pallet are stretched taut
and may whip when cut. Wear eye protection and be very careful
when cutting the straps.
WARNING
Cut the poly straps