00196642-01 - AI BE-Kamera 38 CPP_de_en.pdf - 第15页
Assembly Instruction 4 Introduction Edition 09/2009 15 4 Introduction This manual describes the a ssembly of the co mponent camera typ 38 on the CPP MultiS tar head. 4 4.1 Safety DANGER: Nonobservance of these safety ins…
3 Einbau und Montage Montageanleitung SIPLACE X-Serie
Ausgabe 09/2009
14
Assembly Instruction 4 Introduction
Edition 09/2009
15
4 Introduction
This manual describes the assembly of the component camera typ 38 on the CPP MultiStar head.4
4.1 Safety
DANGER: Nonobservance of these safety instructions may cause injury to
personnel and damage to the machine!
X Please observe the safety instructions in the operating manual of the relevant
machine for all work.
WARNING:
The SIPLACE machines are supplied with line voltage.
Parts of the system therefore carry dangerously high voltages! In specific modules the
voltage is present inside the machine base even when the main switch is turned off.
Handling the machines improperly or touching parts thereof which conduct high voltage
may result in death or serious physical injury as well as extensive property damage.
Before you perform any work on the machine, shut down the operating system and then
ensure that the machine is switched off at the main switch and is disconnected from the
power supply. In addition, the compressed air supply must be turned off at the main
valve of the compressed air unit, in the machine base, and the compressed air lines
must be bled by actuating the needle valve on the compressed air unit.
The area around the linear motors presents a risk of lethal injuries to persons wearing
heart pacemakers. Observe the instructions in Chapter "Special safety instructions for
working in the vicinity of powerful magnetic fields" in the operating and service
manuals. Observe the applicable accident prevention regulations, DIN standards and
special safety codes of your country at all times.
Read and observe the instructions about residual voltages in Chapter "Operational
Safety". Always observe the ESD regulations described in the operating guide, Ch.
Operational Safety.
While performing retrofitting work, always secure the machine to prevent unauthorized
reactivation or access by unauthorized persons, as described in Chapter "Locking the
Machine...".
There is an additional high risk of accidents when working with the programs and
program sections reserved for the service team. These programs may therefore only be
started by specially authorized and trained persons.
4 Introduction Assembly Instruction SIPLACE X Series
Edition 09/2009
16
4.2 Conventions for the use of hazard symbols
This manual contains notes that must be observed to guarantee your personal safety and to
avoid damage to equipment. These notes are highlighted by warning triangles and are indicated
as follows according to the level of risk:
DANGER:
as used in this manual means that death, severe injury or considerable damage to
equipment will occur if the danger instructions are not followed.
WARNING:
as used in this manual means that death, severe injury or considerable damage to
equipment may occur if the warning instructions are not followed.
CAUTION:
as used in this manual means that slight injury or damage to equipment may occur if the
caution instructions are not followed.
NOTE:
as used in this manual provides information on the product or indicates a part of the user
manual that requires particular attention.