00194387-02.pdf - 第17页

Third tape reel adapter for component tro lley R22 Retrofit in structions for third tape reel adapter for component trolley R2, HF series / D3 06/2006 Edition 17 2.3.1 Holder for third t ape reel and splici ng unit (for …

100%1 / 22
2 Retrofit instructions for third tape reel adapter for component trolley R2, HF series / D3 Third tape reel adapter for component trolley
R2
06/2006 Edition
16
: Use two screws on each side to screw the inserting comb onto the fixing bracket.
2
2
: Insert the tape reel holders into the inserting comb.
2
2
Use two screws on each side to screw the insert-
ing comb onto the fixing bracket.
Insert the tape
reel holder
Third tape reel adapter for component trolley R22 Retrofit instructions for third tape reel adapter for component trolley R2, HF series / D3
06/2006 Edition
17
2.3.1 Holder for third tape reel and splicing unit (for machine height 930 / 950 mm)
If the "holder for third tape reel“ and "splicing unit“ options are used at the same time, then the
shortened idler pulley (03003293-0102 ...) must be used on the tape reel holder (see photograph)
because of the tape infeed spring of the splicing unit.
This only applies to the two machine heights 930 / 950 mm. 2
2
2
Shortened idler pulley for "component trolley R2 SIPLACE HF 03020128- xx "
e.g. when feeder module 12 - 16 is used with the splicing unit
2 Retrofit instructions for third tape reel adapter for component trolley R2, HF series / D3 Third tape reel adapter for component trolley
R2
06/2006 Edition
18
2.4 Setting up the adapters and tape reels
On the component trolley, the front and back are defined as follows: 2
2
The adapters must be plugged into the front or back locations, depending on the SMEMA height.2
2.4.1 SMEMA 830 (without splice detection)
The adapter is fitted at the front two holes: 2
2
Tape reels up to 17 inches in diameter may be used. 2
Back
The side on which you
push or pull
Front
The side that is docked
into the machine