RV-2-3DH_SPE_EN.pdf - 第18页
R V -2- 3D H PRODUCT SPEC I FI CA TIONS 15 E xternal tran sformer T hi s ext ernal t rans f orm er steps down the v oltage when the volt age suppli ed to the equi pment i s 200V or m o r e. The t ransf ormer is applica…
RV-2-3DH PRODUCT SPECIFICATIONS
14
7-2. Optional Hardware
Optional head
• UV light
Optional peripherals
•
Board backup unit
* More than board 100mm in width
Can accommodate 70 mm below board.
• External transformer (AC240 V, AC380 V to 430 V)
• Supports for long size machine
• Pad kit vibration proof
• Calibration jig
• Constrain pass unit
UV light
An image capturing function using the UV light is prepared.
Portions where the coating agent is not applied can be detected and coating agent scattering in application
prohibition area can be inspected.
Board backup unit
This is used to correct a large amount of warping on a board, such as a large-size board.
The backup unit is moved up and down via the air motor (drive), and an anti-static sponge is used for the
backup pins.
*1 I cope than board 100mm in width.
*2 There is the domain that is impossible of placement partly.
<Appearance of backup unit>
<UV light is not used.>
<UV light is used.>
RV-2-3DH PRODUCT SPECIFICATIONS
15
External transformer
This external transformer steps down the voltage when the voltage supplied to the equipment is 200V or
more.
The transformer is applicable to 3-phase AC 240V or 3-phase AC 380V to 430V.
Supports for long size board
The inspection area of the long size board is separated into two blocks for inspection.
Inspectable board size and conditions
Max. board width : 630mm
Board depth : 50mm to 300mm
Conditions : Additional sensors need to be installed to support the long size board.
Mark conditions
Prepare an alignment mark at two locations on the diagonal line of the board in each area where the
inspection area is separated into two areas.
<Appearance of external transformer> <Outside dimensional drawing of external transformer>
Area 2
Area 1
RV-2-3DH PRODUCT SPECIFICATIONS
16
8. System Requirements
8-1. System requirements for the client
* If using only for the remote judgment (OLR), the requirements for the server system software options
need to be satisfied since the server system software needs to be installed into the same PC.
Item Specification
Operating
system
• Windows 7 Professional 32-bit, 64-bit
• Windows 8 Professional 32-bit, 64-bit
・Windows10 Professional 32bit、64bit
* The offline editor is supported only for 64-bit.
Processor 2 GHz or faster
RAM
CCC,OLR、RST
SPC、QT
8 GB or more
Offline editor 16 GB or more
Monitor
CCC,OLR、RST
SPC、QT
SXGA（1280×1024）or higher
Offline editor
Full HD（1920x1080）or higher
Hard disk 500 GB or more
Network 1 Gbps Ethernet
Others
.NET Framework 4.0
* Automatically installed during installation.
* Please contact us when using any configuration other than the above.