00195364-0102_Ext_Power_COT_D1_D2_D3_HF.pdf - 第20页
2 External power supply unit for component trolleys from the SIPLACE D1/D2/D3/HF series SIPLACE 11/2006 Edition 20 2 Fig. 3 External power supply unit for component trolleys, D1, D2, D3, HF series 03042437-01 (basic unit…
SIPLACE 2 External power supply unit for component trolleys from the SIPLACE D1/D2/D3/HF series
11/2006 Edition
19
2.3 Overview
The external power supply unit is used to supply a component trolley from the SIPLACE D1, D2,
D3 or HF series, regardless of the type of placement machine. 2
The power supply unit allows a component trolley to be set up externally with feeder modules and
also permits function tests to be carried out. 2
It is also possible to carry out a set-up check using a set-up station PC via the integrated CAN bus
interface. 2
The unit is suitable for mains voltages ranging from 88 to 264 V AC. 2
2
Fig. 2 External power supply unit for component trolleys, D1, D2, D3, HF series 03042437-01 (basic unit)
Multi-function plug
for component trolley
Signal lamp 48 V
Switch for CAN
bus address
(CAN ID)
2 External power supply unit for component trolleys from the SIPLACE D1/D2/D3/HF series SIPLACE
11/2006 Edition
20
2
Fig. 3 External power supply unit for component trolleys, D1, D2, D3, HF series 03042437-01 (basic unit)
Combination
mains connector
Compressed air connection
CAN bus interface
Pneumatic unit
SIPLACE 2 External power supply unit for component trolleys from the SIPLACE D1/D2/D3/HF series
11/2006 Edition
21
2.4 Structure / settings
2.4.1 CAN bus interface
The CAN bus interface is on the back of the device. When used in conjunction with a set-up station
PC, this allows data to be exchanged between the PC and the component trolley. 2
2.4.2 Setting the CAN bus address (location number)
2
2
2
2
Several power supplies (up to 4) may be connected to a
set-up station PC via a CAN bus cable.
On every device is connected, the CAN bus address must
be set using the two switches S1 and S2.
Each device must be given a different address.
Addresses must not be assigned more than once.
The setting should be made as shown below.