DECAN_S1_Maintenance(Eng_Ver1.1)_Print.pdf - 第68页
Mon thly Inspe ction chapt er 5 Nex t Generation, Multi- Functi onal Placer DE CAN S1 M ain ten anc e Ha nd boo k 5-1 3 Cleaning and Lubricating X Frame LM Guide, Ball Screw Step 4 . Re move th e bolts f ixing t he cove …
Monthly Inspection
chapter 5
Next Generation, Multi-Functional Placer
DECAN S1 Maintenance Handbook
5-12
Cleaning and Lubricating X Frame LM Guide, Ball Screw
Monthly Inspection
Tool for Maintenance
Industrial use paper wipe, Lubricator, GREASE-GREASE_AFE-CA, Wrench(M3, M4),
Steel plate with thickness of 2.0mm
Measures
Step 1.
Move the X Frame to front by referring to "Forward
movement of the X-frame" on page 1-3.
Step 2.
Press the 'STOP' and 'RESET' buttons in order after
pressing the 'EMG' button on the OP panel to stop
operation.
For more details, refer to "How to perform emergency stop" on page
1-2.
Cleaning and Lubricating X Frame LM Guide, Ball
Screw
Step 3.
After removing the tension adjustment bolts of the
cover that prevents grease from scattering using a
hex wrench (M4), replace the fixing block if the space
between the cover fixing block and spacer is not 0.5mm.
Caution
Only the personnel specializing in maintenance must disassemble/
assemble the grease scatter prevention cover.
(Time required: 60min / No. M-9)
Monthly Inspection
chapter 5
Next Generation, Multi-Functional Placer
DECAN S1 Maintenance Handbook
5-13
Cleaning and Lubricating X Frame LM Guide, Ball Screw
Step 4.
Remove the bolts fixing the cover in the order shown in
the following figure using a hex wrench (M3).
1
3
4
2
Step 5.
Move the head assembly to the right as far as it goes.
Step 6.
Remove the bolts fixing the cover in the order shown in
the following figure using a hex wrench (M3).
1
3
4
2
Monthly Inspection
chapter 5
Next Generation, Multi-Functional Placer
DECAN S1 Maintenance Handbook
5-14
Cleaning and Lubricating X Frame LM Guide, Ball Screw
Monthly Inspection
Step 7.
Remove the cover from the X-frame.
Caution
When removing the grease scatter prevention cover, exercise great
care so that it will not be bent.
If the cover is bent, it cannot be used. Therefore, a new one must
be purchased.
Step 8.
Clean the LM guide rail and ball screw using an industrial
use paper wipe.