00194910-02.pdf - 第19页
Protective cover 2 Retrofit instructions Protective cover on the SIPLACE X series 04/2006 Edition 19 2.6.3 Safety stickers If it is not already present (as sta ndard up to seri al no.: B3 5/ B39/ B61/ B6 2/ B65/ B66/ B67…
2 Retrofit instructions Protective cover on the SIPLACE X series Protective cover
04/2006 Edition
18
2.6.2 Retrofitting the safety profile
: If it is not already present, stick the hand guard onto the machine cover:
00378375-01 ETP hand guard X series cover, complete
(as standard up to serial no.: B35/ B39/ B61/ B62/ B65/ B66/ B67/ B73 and all after B76).
2
With the long machine cover, the "Hand guard X series cover long“ (03041570-01) may be used
on the right-hand side of the cover without shortening it (855 mm). 2
: On the left-hand side of the cover, shorten the "Hand guard X series cover long" to 745 mm.
: For the short machine covers, shorten the rubber profile of the "Hand guard X series cover
long“ (03041570-01) to 727 mm (on the right) or 560 mm (on the left).
: Stick on the "Hand guard X series cover“ (03041570-01) using the "Tesafix 4965 19 mm 50m
roll“ adhesive tape (00378373-01) on both sides of the cover.
Check that the lengths are correct as described above. The flat part of the L-shaped profile
must lie under the cover, over the middle of the machine, while the high end must end at the
cover.
Without hand guard
With hand guard
Protective cover 2 Retrofit instructions Protective cover on the SIPLACE X series
04/2006 Edition
19
2.6.3 Safety stickers
If it is not already present (as standard up to serial no.: B35/ B39/ B61/ B62/ B65/ B66/ B67/ B73
and all from B76), stick the
"Retrofit kit: Safety stickers for cover, 5m roll“ (item no.: 00378376-01)
onto the machine covers. 2
: Stick the film onto the metal frame of the machine cover.
2
2 Retrofit instructions Protective cover on the SIPLACE X series Protective cover
04/2006 Edition
20
2.7 Replacing the retaining plates for side screens
In some cases, the side screens may be causing an annoying noise or can become detached and
slip down a few millimetres. 2
In these situations, the retaining strips for the side screens must be replaced.
The new strips contain slots. 2
2
: Replace the strips and screw them on lightly using the new screws "DIN EN ISO 7380-M4 x
12-A2“ (item no.: 00319285-01).
: Press the top strip down and tighten the screws.
Press the bottom strip up and tighten the screws.
2
2
Long protective cover
8x
Strip, long (524 mm) Item no.: 00378572-01
Short protective cover
6x Strip, long (524 mm) Item no.: 00378572-01
2x Strip, short (394 mm) Item no.: 00378573-01
Strip, long (524 mm) (00378572-01)
Strip, short (394 mm) (00378573-
Strips