N7201A617E00_0317.pdf - 第313页

NPM-W 2 EJM7DE-MB-12M-00 12-2 -4 Consumable parts replacement

NPM-W2 EJM7DE-MB-12M-00

12-2-3

Adjust the belt

tension

(→P.6-5)

Place the feeder

table cover

(→P.3-3)

Attach the feeder

cart (→P.3-2)

Check the PCB

transfer

Maintenance

12-2

Replacing the PCB transfer

belt of the extension

conveyor (Option) 2

Unlock the

machine and

(→[Operating Procedure]

P.5-2-8)

NPM-W2 EJM7DE-MB-12M-00

12-2-4

Consumable parts

replacement

NPM-W2 EJM7DE-MB-12M-00

Replacing the

batteries 1

12-3-1

Maintenance

12-3

Describes the procedure for replacing the batteries.

●If the battery voltage decreases, a warning message is displayed on the monitor, or the LED indicator lamp

goes out. Replace the batteries with new ones according to the procedure.

●Batteries are used for multiple parts including the control board of the machine. Used batteries should be

disposed of in compliance with the laws or regulations of each country, or contact your local government or

the service agency from which you purchased them.

●Mishandling the batteries could lead to an accidents including leakage, heat generation, explosion or

ignition, or malfunction of equipment. Be sure to observe the following.

・In case battery liquid gets into eyes, wash eyes with plenty of clean water such as tap water. Get

medical attention immediately.

・Do not charge the battery.

・Do not short (+) and (-) of the battery, or do not insert in reverse.

・Do not throw into a fire, heat, disassemble or remodel the battery.

・Do not deform the battery or apply strong impact.

・Immediately remove the drained battery from the device.

●Because the control PCB may break due to static electricity, be careful of handling with using earth band.

●Avoid the control PCB Short-circuiting by putting it directly on the metal surface. It does not cause smoke

or ignition but it may decrease battery life after being replaced.

NOTICE