06_SM481_Service_Manual Flow Manual.pdf - 第7页

P CB Flow 6-3 Chap ter 6. PCB Flow 6.1. PCB Flow 6.1.1. Require d T ool s  + a nd – shape tipped screw drive r set  L-w r en ch s et  Nippe r a nd cable tie 6.1.2. Procedur e to change the PCB flow on conveyor 1. Mani…

PCB Flow

6-3

Chapter 6. PCB Flow

6.1. PCB Flow

6.1.1. Required Tools

 + and – shape tipped screw driver set

 L-wrench set

 Nipper and cable tie

6.1.2. Procedure to change the PCB flow on conveyor

1. Manipulate the teaching box to move the X-Frame to the rear side.

2. Turn Off the PC in normal way. Then turn off the main switch on the front side of the machine.

3. Refers to the sensor to be moved when changing the PCB flow.

4. Disassemble, move and assemble the sensor rail in order as shown in the following figure.

① Unscrew the fixing bolts securing all sensors and sensor brackets and remove them.

② Unscrew the fixing bolts securing the sensor rail and move it to the right. Then assemble

it again.

Quick Load

Sensor

Place Sensor

Input Sensor

Output Sensor

Wait Sensor Bracket

Before

After

Advanced High Speed Flexible Mounter

6-4

③ Assemble the Wait sensor and Placement sensor by changing their position.

④ Assemble the Entry sensor and Exit sensor by changing their position.

⑤ Unscrew the fixing bolts securing the placement stopper and remove it.

⑥ Remove the stopper cylinder and cylinder bracket. Then assemble them by rotating them

by 180°.

Before

After

Before

After

Before

After