00196683-01 - IM Installation Manual Siplace Pro 8.0_en.pdf - 第65页
7 Troubleshooting Installation Manual Edition 03/2010 US SIPLACE Pro 8.0 63 Note Make sure that you log in using an account with administr ator rights. 7
Installation Manual 7 Troubleshooting
SIPLACE Pro 8.0 Edition 03/2010 US
62
Æ Close SQLServer EnterpriseManager and start the SIPLACE Pro application as required.
7.2.2 System feature (e.g. creating a report) not usable right after installation
Error description: 7
In rare cases it is possible that parts of the system are only installed when a specific feature (e.g.
reporting) is used for the first time after installation. If the SetupCD is available in the drive from
where the software has been installed, this post-installation is automatically performed. 7
If the SetupCD is not in the drive (which is most likely the case), invocation of that feature will fail
and produce error messages like "could not load DLL" or even more cryptic like in the following
screenshot. 7
7
Fig. 7 - 12 Error message
Solution: 7
If you experience such messages after installation, please check in the Event Log to see if the
error message is in fact caused by a failed post-installation. Plese follow these steps to to this: 7
Æ To open the Event Viewer, go to Start Menu ->Run, enter "eventvwr" and click OK.
Æ Select "Application Log".
All logged application events will be displayed. The latest is at the top of the list.
Æ Check for entries of type "Error" from Source "Msilnstaller" at the correct time. If you find such
entries with a timestamp matching the time when you received the error, it is likely that a post-
installation has been invoked and failed due to the missing Setup CD.
Æ If no such entries are found in the eventlog, the error message has another unknown reason.
7
If the above check has had a positive result (point 3 above), the problem can be solved by: 7
Æ inserting the SetupCD in the drive from where you installed the software. If you installed from
a network drive, be sure that you use the same share with the same drive letter.
Æ or by trying to reinvoke the feature which just failed. As soon as the post-installation has been
performed (with or without user feedback), the feature should start as expected. If it doesn‘t,
the error message has another unknown reason.
7 Troubleshooting Installation Manual
Edition 03/2010 US SIPLACE Pro 8.0
63
Note
Make sure that you log in using an account with administrator rights. 7
Installation Manual 7 Troubleshooting
SIPLACE Pro 8.0 Edition 03/2010 US
64
7.2.3 Error message after repair installation at Windows Vista
Error description: 7
You perform a repair installation at Windows Vista without changing anything. After the repair in-
stallation has successfully completed following screenshot ist displayed. 7
7
Fig. 7 - 13 Repair installation at Vista
Solution: 7
Æ Click Cancel because this message has no influence on the program and can be ignored.
7