00196019-02.pdf - 第18页
2 Assembly Instructions Tape cutter freque ncy controller SIPLACE S / F / HS / C- / HF- / X- / D-series Controller 02/2008 Edition 18 2.4 Assembly : Remove all 6 connectors for electronic valves and cylinder sensors fro …
Controller 2 Assembly Instructions Tape cutter frequency controller SIPLACE S / F / HS / C- / HF- / X- / D-series
02/2008 Edition
17
2.3 Safety instructions
WARNING
The safety instructions from the "Operational safety" chapter of the user manual and servicing in-
structions take precedence over these instructions. 2
The SIPLACE placement machines are supplied with mains voltage.
Consequently parts of these systems carry dangerous voltages! This voltage is present at certain
modules inside the machine base, even when the machine is switched off at the main power
switch.
Incorrect handling of the placement machine or touching live parts of the machine can result in
death or severe injury, and considerable damage to equipment.
BEFORE starting any work, shut down the operating system correctly, then switch the machine
OFF at the main power switch and disconnect from the main power supply. In addition, the com-
pressed air supply must be switched off at the compressed air unit's main valve in the machine
base and vented by actuating the needle valve on the compressed air unit.
There is DANGER for heart pacemaker wearers in the vicinity of the linear motors, as described
in detail in the "Special safety instructions for working in the vicinity of strong magnetic fields"
section of the user manual and service manual.
Always follow the accident prevention regulations, DIN or other standards and special safety
rules applicable in your country.
Pay attention to the information concerning residual voltages in the Operational Safety chapter.
Follow the ESD regulations as described in the operational safety section of the operating
instructions.
During the retrofit, always secure the machine to prevent access by other people and to prevent
it being switched on again. The procedure is described in the “Locking the machine…” section of
the user manual.
Working with the SITEST program further increases the risk of accident.
The SITEST program must only be used by authorized and trained personnel.
2
2.3.1 Definitions
2
Note 2
2
2
2
Vorsicht 2
2 Assembly Instructions Tape cutter frequency controller SIPLACE S / F / HS / C- / HF- / X- / D-series Controller
02/2008 Edition
18
2.4 Assembly
: Remove all 6 connectors for electronic valves and cylinder sensors from the control board.
2
2
2
2
2
2
2
2
2
2
2
2
Controller 2 Assembly Instructions Tape cutter frequency controller SIPLACE S / F / HS / C- / HF- / X- / D-series
02/2008 Edition
19
: Connect the added cable to the controller unit:
Each connector is marked with a number. This number must be the same as the number at the
controller unit.
2
Please be careful about the electronic valve connector direction. The connector can be connected
in reverse direction. 2
Verify each connector via number and connection configuration. 2
2
2
2
2
2
2
connectors for
control board
new tape cutter frequency controller
cable with connectors