Printer 710-810 v9 Covers.pdf - 第25页
COVERS PRINTER COVERS Chapter Issue 10, Jul 16 Technical Reference Manual 3.25 cable. 5. Repeat S teps 3 and 4 for the other rear corner p anel, if required. Front Corner Panels T o remove the front corner p anels, carry…
COVERS
PRINTER COVERS
3.24 Technical Reference Manual Chapter Issue 10, Jul 16
2. Tilt the top of the panel away from the machine and lift the panel clear, taking
care not to damage the earth cable.
Safety Covers To remove the rear fixed printhead cover, carry out the following:
1. Remove the rear panel (as detailed previously).
2. Using an 4mm Allen key, undo the two captive screws.
3. Remove the earth cable from the cover and lift the cover clear of the
machine.
Rear Corner Panels To remove the rear corner panels, carry out the following:
1. Remove the rear panel (as detailed previously).
2. Remove the rear fixed printhead cover (as detailed previously).
3. Using an 4mm Allen key, undo the appropriate two captive screws.
4. Lift the panel clear of the machine, taking care not to damage the earth
View on Rear of Machine
M5 Cap Screwstive
COVERS
PRINTER COVERS
Chapter Issue 10, Jul 16 Technical Reference Manual 3.25
cable.
5. Repeat Steps 3 and 4 for the other rear corner panel, if required.
Front Corner Panels To remove the front corner panels, carry out the following:
1. Open the front printhead cover.
2. Remove the front panel (as detailed previously).
NOTE
1. Before a front corner panel can be removed, the control switches (jog
switch and system switch or jog switch and E Stop) must be disconnected.
2. Before removing the right hand front corner panel, disconnect the con-
nector for the printhead safety switch.
View on Rear - Right Quarter
M5 Cap Screwstive
Left Rear
Corner Panel
Right Rear
Corner Panel
Contact AssemblySwitch Body
Release SlotRelease Slot
View on Rear of Switch
COVERS
PRINTER COVERS
3.26 Technical Reference Manual Chapter Issue 10, Jul 16
3. To disconnect the system switch and jog buttons carry out the following:
a. Locate the two release slots in the contact assembly part of the switch.
b. Insert the switch release tool (Part No 188647) into the slots and push
until the release tool clicks into place.
c. Leaving the switch release tool in position, pull the contact assembly from
the switch body.
d. Remove the switch release tool from the contact assembly.
NOTE
To refit the contact assembly to the switch body, using the locating
keyway, push the two units together until they click into place.
4. To disconnect the E Stop, turn the latch anti-clockwise and pull the contact
assembly away from the cover.
5. Undo the appropriate M5 captive screws (refer to rear corner panels figure
for screw position).
6. Lift the panel clear of the machine, taking care not to damage the earth
View on Rear of Switch
Switch Release Tool
Switch Body
Contact Assembly
Contact Assembly Latch
View on Rear of E Stop