192277 - Micron Technical Reference Volume 3.pdf - 第138页
RISING TABLE MODULE - STYLE 1 REPLACEMENT PROCEDURES 27.8 Technical Reference Manual Chapter Issue 9, Aug 14 REPLACEMENT PROCE DURES Rising T able Drive Belt W ARN ING HOT SURF ACES. THE SURF ACE OF TH IS COMPONENT OR SU…
RISING TABLE MODULE - STYLE 1
ADJUSTMENTS AND SETTINGS
Chapter Issue 9, Aug 14 Technical Reference Manual 27.7
35. Carry out the following calibrations:
• Vision Height, Camera System Module chapter refers
• Print Height, Calibrations section of this chapter refers
RISING TABLE MODULE - STYLE 1
REPLACEMENT PROCEDURES
27.8 Technical Reference Manual Chapter Issue 9, Aug 14
REPLACEMENT PROCEDURES
Rising Table Drive Belt
WARNING
HOT SURFACES. THE SURFACE OF THIS COMPONENT OR SURROUNDING
AREA MAY BECOME HOT DURING PROLONGED OPERATION. CARE TO BE
TAKEN WHEN WORKING IN THE VICINITY OF THIS COMPONENT.
1. Gain access to the rising table motor.
2. Slacken one of the studs and unscrew it until the rubber buffer is in contact
with the mounting plate. Tighten the stud. Do not adjust the other stud.
3. Using a 5mm Allen key, slacken the two rising table motor securing screws.
4. Slide the rising table motor towards the leadscrew to slacken the drive belt.
5. Remove the drive belt and discard.
View From Front of Rising Table Assembly
Rubber Buffer
Mounting Plate
Stud
Table
Spring Balance
Attachment Point
Leadscrew
Rising Table
Motor Securing
Screws
View From Rear of Rising Table Motor Assembly
RISING TABLE MODULE - STYLE 1
REPLACEMENT PROCEDURES
Chapter Issue 9, Aug 14 Technical Reference Manual 27.9
6. Fit the replacement drive belt.
7. Using the spring balance attachment point, tension the drive belt to 6kg.
8. Whilst maintaining this tension, tighten the rising table motor securing
screws.
9. Slacken the stud adjusted in Step 2 and set the height of the buffer level with
the other stud. Tighten the stud.
10. Carry out Rising Table Home Setting, Adjustments and Settings section of
this chapter refers.
View From Rear of Rising Table Motor Assembly
Spring Balance
Attachment Point
6kg
Tension
Spring Balance