EUKYX-199-5100_G5S2_Instruction_Vol5_E.pdf - 第34页
Safety Precautions EUKYX-Safety 199-X100 Safe-26 No. Al er t L ab el s an d De sc rip ti on (7) CAUTION 10-0146- Do not let your finger get caught in this. An injury will result. Description ● Whe n a cove rs ( do or t y…
Safety Precautions
EUKYX-Safety
199-X100
Safe-25
No. Alert Labels and Description
(4)
Description
●
Only well-trained service personnel shall replace the cutter blades. Otherwise, a hand injury,
etc., will result.
(5)
Description
●
This label indicates that high voltage is applied to the area. Residual voltages may remain
behind for a few minutes in the internal devices of the machine after power interception.
Before performing maintenance work, wait until the charge lamps of the DC power supply and
the servo amplifier go "OFF" in 10 minutes or more after the power breaker is set to "OFF".
(6)
Description
●
Before connecting to the breaker's primary power leading-in section, connect the grounding
cable (PE). Imperfect grounding will cause an electric shock.
5. Alert Labels
Safety Precautions
EUKYX-Safety
199-X100
Safe-26
No. Alert Labels and Description
(7)
CAUTION
10-0146-
Do not let your finger
get caught in this.
An injury will result.
Description
●
When a covers (door type) is opened or closed, be sure to hold the grip firmly and slowly move
the cover up or down. Otherwise, your hand and fingers might get caught in the door and get
injured.
(8)
Description
●
Before maintenance work, shut off the power breaker and lock it with the padlock.
●
Even when the power breaker is set to "OFF", the primary line is powered, making it possible to
cause an electric shock.
Be sure to completely stop the power supply to the machine before maintenance work.
(9)
Do not put any object
on this section.
This might damage the machine.
10-0326A
Description
●
Do not put any object on the machine. Doing so might damage the machine. This might damage
the machine.
5. Alert Labels
Safety Precautions
EUKYX-Safety
199-X100
Safe-27
No. Alert Labels and Description
(10)
CAUTION
Your hand might be caught in the moving section. Do not
put your hand into the cover opening during the machine
operation.
Pay attention to the moving
mechanisms!
10-0249-
Description
●
Do not put your hand inside the machine while the machine is running.
Otherwise, your hand may be trapped in the moving mechanisms, causing injury.
(11)
10-0339-
CAUTION
When the feeder base is moved up and down
and your finger is put into the moving section,
you might get injured.
Do not put your hand into the moving section.
Your hand or finger might be crushed.
Description
●
Do not put your hand in the moving area while the feeder base is moving up or down. While the
LED of a [FEEDER READY] switch is flickering, it indicates that the feeder base is moving
upward or downward.
(12)
10-0334-
Strong Magnetism!
Do not bring any metal close to this.
Otherwise, such metal will easily be
magnetized and attracted,
causing an injury to the operator.
CAUTION
Description
●
Strong permanent magnets are used in the moving sections of the X/Y beam.
• Do not bring any metal of high magnetizability close to this. Otherwise, such metal will easily
be magnetized and attracted, causing an injury to the operator or breakdown of the machine.
• Do not bring any object such as a magnetic card or a watch close to the magnets. Such an
object can easily be affected by the magnetism. Otherwise, the data of the magnetic car might
be cleared or a watch, etc., may be damaged due to the strong magnetism.
5. Alert Labels