SA_HF_intern_0194307-02_eng.pdf - 第9页
SIPL ACE HF-Ser ies Safety Ins tructions for Work on the Cut ting Devi ce Safe ty Sa fet y In s tr ucti o n s 2 Copy ri ght © 200 4 S ie m ens 0019 43 07- 02 Is su e 1 1/ 2004 2-3 DANGER If you wish to w ork on the ta …
2
Safety
Safety Instructions
SIPLACE HF-Series
Safety Instructions for Work on the Cutting Device
2-2
00194307-02 Issue 11/2004 Copyright © 2004 Siemens
DANGER OF CRUSHING
Danger of crushing for persons with passive metal implants (e.g. plates and screws).
Do not reach into the machine or bend towards it when the safety covers are open. Do not bring any metal objects into
the area.
CAUTION - STRONG MAGNETIC FIELDS
There is a risk that the strong magnetic fields could corrupt data on data media or credit controller boards and check
controller boards.
2.1.3 Safety Instructions for Work on the Cutting Device
DANGER
The machine must be switched OFF and disconnected from the mains before you perform any work in the area of
the cutter.
In addition, the compressed air supply must be turned off at the main valve of the compressed air unit in the
machine frame and the compressed air lines must be bled by actuating the needle valve on the compressed air
unit.
Always secure the machine against unauthorized reactivation
SIPLACE HF-Series
Safety Instructions for Work on the Cutting Device
Safety
Safety Instructions
2
Copyright © 2004 Siemens 00194307-02 Issue 11/2004 2-3
DANGER
If you wish to work on the tape cutter, you must disconnect the machine from the mains supply and compressed
air supply.
Wait until the operating pressure has dropped to 0 MPa.
Wear appropriately thick protective gloves when working near the blades/the tape deflector!
There is a high risk of injury from stationary blades and moveable blades and from the tape deflector of the cutter,
even when the machine has been turned off!
Never reach into the pneumatic cutter from below or into the empty-tape duct from above, not even to resolve a
problem (e.g. when tape is jammed).
WARNING
Wear appropriately thick protective gloves.
When removing the cutter, hold it only on the left and right, on the outside.
Never support the cutter on your body (e.g. on your knee or thighs). Do not place your feet under the cutter.
You could injure yourself severely or at least damage your clothing!
Make sure that no one can injure themselves on the cutter after it has been dismantled!
2
Safety
Safety Instructions
SIPLACE HF-Series
Safety Instructions for the Power Supply
2-4
00194307-02 Issue 11/2004 Copyright © 2004 Siemens
2.1.4 Safety Instructions for the Power Supply
DANGER
The machine is supplied with 3 x 400 V~ (or 3 x 204 V~ / 3 x 230 V~ / 3 x 380 V~ / 3 x 415 V~) ± 5 %, 50/60 Hz mains
voltage.
Consequently, parts of the system carry potentially lethal voltages, even when it is switched off at the main switch.
Incorrect handling of the placement system can therefore result in death, severe injury or considerable damage to
equipment.
Measurements and repairs must always be carried out by appropriately qualified personnel.
Always follow the safety instructions in the Siplace HF Operating Instructions.
Always follow the applicable accident prevention and VDE regulations (particularly DIN EN 60 204, part 1) or the
regulations specific to your country.
Before starting any repairs, switch off at the main switch and disconnect the placement system from the main
power supply.
Always secure the machine against unauthorized reactivation. If these instructions are not followed, it is possible to
touch live parts, which could result in death or severe injury.