CM88Maintenace2x.PDF.pdf - 第42页
Page 3-14 3Y3C-E-MMD03-A02-00 Check and Solutions 3-2-8 A Stage T ape Float Error (Feeder Lifting (Front and Rear)) B Stage T ape Float Error (Feeder Lifting (Front and Rear)) 1. Setting the tape feeder properly Ensure t…
Page 3-13
SOLUTIONS FOR ERROR
3
3Y3C-E-MMD03-A02-01
Check and Solutions
3-2-6 Cover Open
1. Closing the safety cover
Check that the safety cover indicated as the error is not opened, and close it if it is opened.
3-2-7 Safety Cover Open
1. Closing the safety cover
Check that the safety cover indicated as the error is not opened, and close it if it is opened.
Front cover
4G3C-AA014G3C-AF01
Rear cover
3Y3C-AH01
3Y3C-AG01
A stage safety cover
B stage safety cover
Rear center safety cover
Page 3-14
3Y3C-E-MMD03-A02-00
Check and Solutions
3-2-8 A Stage Tape Float Error (Feeder Lifting (Front and Rear))
B Stage Tape Float Error (Feeder Lifting (Front and Rear))
1. Setting the tape feeder properly
Ensure the front press cover and toggle lever are set as shown.
The error is displayed not only for setting the front holder cover and toggle lever, but also for
interrupting the detecting area of sensor. Check for a foreign body in the area, and remove it.
(The following figure shows the light emitting and receiving parts on the A stage, and those on B
stage are at the opposite position.)
Toggle lever
Front press cover
Sensor detection area
TAPE-C9-AA
3Y3C-115E
A stage
Light emitting
part
Light receiving
part
B stage
3Y3C-AI01
15UHC2AA
3Y3C-116E
Sensor detection area
Page 3-15
SOLUTIONS FOR ERROR
3
3Y3C-E-MMD03-A02-00
Check and Solutions
3-2-9 Production End Signal Detected
1. Canceling the production end signal
As the production end signal is output from the front stocker of slotted magazine loader or stacking
magazine loader, press the LINE START switch to cancel the production end signal.
3-2-10
Adhesive Tape Feed Rod Descend (Adhesive Tape Feed Interlock)
Tape Feed Rod Descend (Adhesive Tape Feed Interlock)
Pickup Pos Head Descend (Pickup Head Interlock)
Mount Pos Head Descend (Mount Head Interlock)
1. Checking the state of cam follower (or Rod end)
Move up and down the part circled in the lower figure by hand, and check the wear and damage. If
wear or damage is found, make contact with us for changing.
Upper operation panel
LINE
START
PROD.
END
PUT IN
MAGAZINE
RESET
STEP
TAKE OUT
MAGAZINE
POWER
MANU.
PITCH
EMERGENCY
PRODUCTION
COUNTER
R
S
E
T
E
R
S
E
T
E
1
23
4
AUTO
033C-PS006
Check position for the wear and damage.
01DTC2AB
01DPC2AA
01DQC1AA