M1_ServiceManual_e.pdf - 第13页
1 Installation 1-6 Connecting Loader with Mounter There is an entrance sensor at the entrance of the mounter. If the loader is installed upst ream of the mounter, the entrance sensor must be m oved to avoid interruption …
1 Installation
1-5
④ When the conveyor has become level, check if the height is 900+/-20 mm. Then fix the adjust feet
with nuts.
⑤ The head assy. is fixed to the XY shafts with nylon ties. Take them off with nippers.
⑥ Connect the power cable and ground line independently of other machines which may be a noise
source, such as a compressor, welding machine.
⑦ Connect the air supply coupler 65SN or 85SN (Nitto) or an alternate to the air coupler on the filter
regulator in the mounter. Then, make sure the filter regulator indicates 0.49 MPa (5 kgf/cm
2
).
Level
Air Coupler 65SN or 85SN
Air Coupler
Filter Regulator
1 Installation
1-6
Connecting Loader with Mounter
There is an entrance sensor at the entrance of the mounter. If the loader is installed upstream of the mounter,
the entrance sensor must be moved to avoid interruption with the loader.
After the sensor has been moved, align the conveyors for smooth board transfer.
NOTE: While moving a sensor and aligning conveyors, the power to the mounter must be turned off.
a: The sensor position without a loader.
b: The sensor position with a loader installed upstream of the mounter.
Loader rack
Loader’s frame
Normal position
Entrance Sensor
Position with loader installed
1 Installation
1-7
Pre-Process and Post-Process of Mounter
Connecting Pre-Process and Post-Process
When using other manufacturer’s machines as the pre-process or post-process, connect them as shown in
the below diagram. No-voltage output (relay) is recommended for post-process.
Standard spec. : Upper half of the diagram.
SMEMA Interface spec. : Whole diagram.
＊INPUT CIRCUIT
＊INPUT CIRCUIT
2
1
CN2 CN1
Post-process
Connector (Cable side)
AMP
206044-1(plug)
66099-2 or equivalent (pin)
206070-1(cable clamp)
Connector (Mounter side)
AMP
206043-1(receptacle)
MounterPre-process
BOARD
AVAILABLE
BOARD
AVAILABLE
MACHINE
NOT READY
2.2K Ω
10K Ω
10K Ω
10K Ω
10K Ω
COM
Input
terminal
＊INPUT CIRCUIT
+5V
30VDC 1A or less
100VAC 0.5A or less
RELAY
RELAY
MACHINE
NOT READY
3
4
2
1
3
4