M1_ServiceManual_e.pdf - 第35页
3 Mechanical Section 3-11 ■ Lubrication Points for X/Y-axis, C onveyor, Feeder bank plates Y ax i s LM guide Y a x is b all sc re w Conve yor adj usti ng screw Conve yor gui de shaft X axis ball screw X axis LM guide Fee…
3 Mechanical Section
3-10
Lubrication
Lubrication Points
Lubricate the specified portions listed below with cotton swab soaked with lubricant.
UNIT PORTION LUBRICANT FREQ.
Mounter Ball Screw of X-axis Grease Every two weeks
LM Guide of X-axis (Upper and Lower) Grease Every two weeks
Ball Screw of Y-axis (Right and Left) Grease Every two weeks
LM Guide of Y-axis (Right and Left) Grease Every two weeks
Feeder Bank Plates Grease Every two weeks
Conveyor Width Adjusting Screw Grease Monthly
Conveyor Guide Shaft Grease Monthly
Ball Screw of Z-axis Grease Every two weeks
Spline Shaft of Z-axis Grease Every two weeks
Linear Way of Z-axis Grease Every two weeks
Ball Screw of S-axis Grease Every two weeks
LM Guide of S-axis Grease Every two weeks
Nozzle Silicone Grease Weekly
MX-20 Ball Screw Grease Monthly
(OPTION) Slide Pack Grease Monthly
Slide Pack (Shuttle Unit) Grease Monthly
MX-40 Shuttle Clamp Grease Monthly
(OPTION) V-Guide Track Grease Monthly
Ball Screw Grease Monthly
Slide Pack Grease Monthly
Slide Shaft Grease Monthly
Slide Shaft (Relay Unit) Grease Monthly
Spline Shaft (Relay Unit) Grease Monthly
MX-ST2 Shaft Grease Monthly
(OPTION) Parallel Pin Grease Monthly
Downside of cap Grease Monthly
Contact part of shaft and cap Grease Monthly
Contact part of shaft and bracket Grease Monthly
NOTE: Do not apply excessive oil/grease. This may cause oil/grease scattering when the mounter is in operation.
3 Mechanical Section
3-11
■ Lubrication Points for X/Y-axis, Conveyor, Feeder bank plates
Y axis LM guide
Y axis ball screw
Conveyor adjusting screw
Conveyor guide shaft
X axis ball screw
X axis LM guide
Feeder bank plates
3 Mechanical Section
3-12
■ Lubrication Points for Z-axis
Remove the cover.
Spline Shaft
Grease Hole
Linear Way
Ball Screw