00197737-07_IM_WES7_DE_EN.pdf - 第16页
Windows Embedd ed Standard 7 / Inst allation Manual 12/2017 Edition 16 5 Installing and C alibrating the Touch Screen Now the touch scree n has to be installed and calibrated (statio n computer only). For this, perform t…
Windows Embedded Standard 7 / Installation Manual 12/2017 Edition
15
The following window is displayed:
Figure 4-2: Window "SIPLACE Windows Embedded Standard 7 Configurator"
► Click on the required hardware to select it and follow the further instructions displayed in the
succeeding windows.
► If necessary, enter the station IP-address for SIPLACE Pro LAN (required for a station
computer only).
The SIPLACE settings are automatically performed and the computer reboots.
After the reboot, you are logged on as Operator (station computer) or the Windows login window is
displayed (Coplan / BulkFeeder X computer).
► If no touch screen is used (Coplan / BulkFeeder X computer), remove the software CD from the
DVD drive or release the USB stick and remove it from the USB interface.
NOTICE
SIMATIC BoxPCs 627C/827C:
When shutting down a machine via the machine software GUI, the computer will be
switched off at the end and the It is now save to turn off the Computer
message will be displayed. For technical reasons, this message will not be displayed on
the SIMATIC BoxPCs 627C/827C.
Only the short No signal input or kein Eingangssignal monitor message is
displayed, thereafter the monitor LED starts flashing or changes from green to red.
Windows Embedded Standard 7 / Installation Manual 12/2017 Edition
16
5 Installing and Calibrating the Touch Screen
Now the touch screen has to be installed and calibrated (station computer only). For this, perform
the following steps:
► Log on as ASM_Admin and enter a password.
► In the "SIPLACE Windows Embedded Standard 7 Configurator", click on the Add-ons and
Touch Screen Driver button under Optional Installation to select and install a touch screen
driver. Follow the installation instructions.
► After installation, calibrate the touch screen as described in the installation manual for the
station software.
► Remove the software CD from the DVD drive or release the USB stick and remove it from the
USB interface.
If you have installed Windows Embedded Standard 7 on a station computer, the installation is
completed now.
► Install the SIPLACE machine software as described in the installation manual for the station
software.
If you have installed Windows Embedded Standard 7 on a Coplan / BulkFeeder X computer:
► Follow the instructions in the respective Assembly Instruction for the 3D Coplanarity Module,
item no:s. [00195344-xx] (for X-series), [00196842-xx] (for SX1/SX2) and [00197395-xx] (for
X-series S) or the instructions in the Operating Manual for BulkFeeder X, item no. [00198045-
xx] if you install Windows Embedded Standard 7 on a Coplan or BulkFeeder X computer.
► Install the SIPLACE machine software as described in the installation manual for the station
software.
Windows Embedded Standard 7 / Installation Manual 12/2017 Edition
17