00196439-0202_MA_Option_Durchtransport_HF-Serie_X-Serie_D3.pdf - 第24页
Assembly instructions Pass-through transpo rt for SIPLACE HF-series / X-series / D3 04/2010 Edition 24 : If there is no hole in the conveyor control housin g for fitting the button (see photogr aph), it must be drilled a…
Assembly instructions Pass-through transport for SIPLACE HF-series / X-series / D3
04/2010 Edition
23
: Loosen the two screws shown in the photograph.
Screws
2
: Pull out the conveyor control drawer unit.
2
To allow optimum access to the work area, it may be necessary to loosen the screw on the pneu-
matic docking unit and pull it out slightly. 2
2
Assembly instructions Pass-through transport for SIPLACE HF-series / X-series / D3
04/2010 Edition
24
: If there is no hole in the conveyor control housing for fitting the button (see photograph), it must
be drilled as shown in the following drawing.
2
Make sure that no metal swarf drops into the plug-in board or machine, as this could cause a short-
circuit. 2
Hole
2
Assembly instructions Pass-through transport for SIPLACE HF-series / X-series / D3
04/2010 Edition
25
: Fit the module as shown in the photograph.
Module
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2