Printer 710_810 v8 Preventive Maintenance.pdf - 第46页
PREVENTI VE MAINTE NANCE MONTH LY MAINT ENAN CE 33.46 Technical Reference Manual Chapter Issue 6 Oct 06 Summ ary/ Rema rks Signed: Date:
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
Chapter Issue 6 Oct 06 Technical Reference Manual 33.45
Monthly Hardware Check
General Maintenance Tick
Check the condition of the board clamps.
Cycle the board clamps ensure that clamping and release is smooth.
Cycle the Test 265test 1 board on the transport rails ensure smooth operation.
Clean the table top of paste and debris, apply a wipe of light oil.
Clean the transport rails of paste and debris.
Inspect tooling pins/assemblies/modules for wear, replace any formflex tooling modules leaking excessively.
Inspect the air filters and clean/recommend replacement.
Screen Alignment Tick
Inspect the wiring and connections.
Inspect the three striker plates, clean and apply a wipe of light grease.
Check the actuator fixed ball at the end of the actuator shaft is clean.
Check all actuators home correctly.
Screen Change Tick
Remove and clean the auto drip tray.
Fully extend the auto drip tray telescopic plungers and clean.
Clean the screen stop actuator arm lever.
Clean the screen at stop sensor.
Refit the auto drip tray and check operation of the screen change mechanism.
Chase Tick
Inspect the condition of wiring/pneumatic connections.
Check operation of the chase clamps.
Clean and lubricate with light oil, the omni track bearings and the underside of the track plates.
Clean the left and right screen at centre optos.
Clean the stencil guide strips of debris/paste.
Check operation of the ASM.
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
33.46 Technical Reference Manual Chapter Issue 6 Oct 06
Summary/Remarks
Signed: Date:
PREVENTIVE MAINTENANCE
CLEANING, LUBRICATION AND MAINTENANCE DIAGRAMS
Chapter Issue 6 Oct 06 Technical Reference Manual 33.47
CLEANING, LUBRICATION AND MAINTENANCE DIAGRAMS
Figure 33-1 Rising Table
A
Tooling (clean)
Manual Tooling Plate (clean)
View on Rear of Rising Table
Transport Rail Drive Belt
Rising Table Drive Belt
Rising Table Ballscrew
Transport Rail Ballscrew
(in 2 positions)
Rising Table Motor
Linear Bearing Block
(in 4 positions)
View on Arrow A
Sensor Vane
Vertical Linear Bearing Guide Rails