TP2171.P-Tool for Dual Lane Machine.pdf - 第24页

SMT Software Eng ineering Group IM Operations Y AMAHA MOTOR CO., L TD. MDOC-SOFT50069 24/27 Mount La ne Feature Lane1 Output resu lts of mounting in La ne1. Lane2 Output resu lts of mounting in La ne2 [Mount M ode] is di…

100%1 / 27
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50069
23/27
2.6. Producing the different kind of board ’Type-N’ option
(V1.25STD R1.000 or later)
2.6.1. Summary
The machine that supports ‘Type-N’ (Producing the Different Kind of Board) is capable of
producing two board data at the same time.
Optimizer assigns feeders to a near side of the plates from the mount lane so that it is possible
to switch board data individually with respecting to each lane (Feeders of front lane parts are
assigned to front plate and feeders of rear lane parts are assigned to rear plate.).
Each head unit mounts boards on their closer side of the lanes.
2.6.2. Setting Method
<Optimizer>
Select [Optimizer] – [set optimization parameters] – [Single Lane Board] – [Mount Lane] and
[Mount Mode]. This is enabled only when the kind of the selected board data in [Target / Save
Board] is ‘Single Board Data’. (When the kind of the board data is ‘Combined Board Data’, the
behavior of the optimizer is the same as that of other than producing the different kind of board)
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50069
24/27
Mount Lane Feature
Lane1 Output results of mounting in Lane1.
Lane2 Output results of mounting in Lane2
[Mount Mode] is displayed only when Type-N option is enabled in all machines in the line.
Mount Mode Feature
Parallel Lanes
(Default)
Optimizer assigns feeders to the near side plate from the mount
lane so that it is possible to switch board data individually with
respecting to each lane.
In the following cases, an error occurs during the optimization
(Ea17853: Feeder Overflow etc.).
1. Feeders overflow from the designated side of feeder plate. (In
this case, change [Mount Mode] to ‘Each Lanes’).
2. Tray changer parts are used in target board data and no tray
changer exists in the designated lane for ‘Mount Lane’. (In this
case, change [Mount Lane] to the lane that has tray changer.)
Alternate Lanes Feeders are assigned to all feeder plates.
The machine mounts using both of the head unit for one kind of
board data.
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50069
25/27
<Feeder Viewer>
Select [Feeder Viewer] - [Product Board List] - [Optimized Lane] and [Mount Mode].
Setting method is similar to the case of optimization.