TK29609.Auto Scale Correction.pdf - 第3页

 SMT Software Engineering Group  IM Operations Y AMAHA MOTOR CO., L TD  MDOC-SOFT50390 3/8  3. Setting Metho d Settings to use this function are as fol lows. 3.1. Board data On the [Inspection] - [Inspection] tab, s…

100%1 / 8
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD
MDOC-SOFT50390
2/8
1. Machine Type and Software Version
This function is supported for the following machine type and software version.
Table 1.1 Machine and Version
Machine Version Note
YSP V3.45STD R1.000
YCP10 V4.48STD R1.000
2. Overview
At print inspection, view of the inspection camera may warp if the height of board surface
differs because of board warpage. In that case, positions of inspection results may be
misaligned.
“Auto Scale Correction” automatically corrects the scale of inspection camera according
to the actual height of board surface.
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD
MDOC-SOFT50390
3/8
3. Setting Method
Settings to use this function are as follows.
3.1. Board data
On the [Inspection] - [Inspection] tab, set [Auto scale] to “Use”.
Fig 3.1 [Inspection] - [Inspection] screen
Table 3.1 Board data setting item
Item Default Range Description
Auto Scale Not Use Not Use
Use
Select use or not use “Auto Scale Correction”.
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD
MDOC-SOFT50390
4/8
3.2. Machine Setting
Make settings of Auto Scale Correction on [Machine] - [Machine Data] – [Mechanical] –
[Position/Specification].
Fig 3.2 Position/Specification
Table 3.2 Auto Scale Correction setting
Item Default Range Description
Max correct 1.000 -9999.999
～9999.999
Maximum value of scale correction
Min correct 0.980 -9999.999
～9999.999
Minimum value of scale correction
Weighting
factor
Not Use Not Use
Use
Coefficient is considered at calculation of
scale correction value according to solder
number. (*)
Angle 26.020 -9999.999
～9999.999
Angle of the inspection camera view
(*) If there are only few inspection objects in a view, print position gap may be wrongly
judged as scale gap, and the inspection results may be incorrect. In that case, use
“Weighting factor”.