W08b_c_W04b Feeder Operation Manual_074133.pdf - 第6页

W08b(c), W04b Feeder Operation Manual Page 6 of 10 For 8 mm paper tape, spec ify as shown below. For 8 mm emboss tape, specify as shown below. For 8 mm black flat tape, specify as shown below.

W08b(c), W04b Feeder Operation Manual Page 5 of 10

3. Using the W08b(c), W04b Feeder

The pickup height is different for paper tape and emboss tape with the W08b(c), W04b feeder.

Therefore, the package type of the tape parts is identified automatically and the part height adjusted

accordingly.

3.1 Automatic identification of tape part package type

Feeder resupply guidance

Setup the parts on the feeder according to the guidance.

The following is displayed in the width field.

[8]: 8 mm feeder (paper, emboss)

[8PB]: 8 mm feeder (black flat tape)

The machine automatically identifies the type of package type of the part set at the feeder,

determines the suitable pickup height for the tape type, and performs production. Specify the job as

shown below to enable automatic identification.

Specify [Yes] for the [Package Data] – [Package Process] – [Check Type with Vision] setting.

W08b(c), W04b Feeder Operation Manual Page 6 of 10

For 8 mm paper tape, specify as shown below.

For 8 mm emboss tape, specify as shown below.

For 8 mm black flat tape, specify as shown below.

W08b(c), W04b Feeder Operation Manual Page 7 of 10

3.2 Feeder operation panel

Two new switches have been added to the FIFW04b, FIFW08b(c) feeder.

• Tape feed speed switch

Sets the tape feed speed. H is the standard; set to L for low speed.

• Tape type changeover switch

Sets the tape type. Cannot be used from NXT V5.07.

• Feed pitch setting switch

Sets the indexing pitch.

• LED lamp

PWR (green): power is connected.

ERR (red): a tape indexing error has occurred.

• Forward button

Advances the feed tape one specified indexing pitch only.

• Origin positioning button

Advances the part to the sprocket stopping position according to origin sensor.

• Reverse button

Retracts the feed tape one specified indexing pitch only.

• Cover tape feed button

Takes up any slack in the cover tape.

For more information, refer to the “Fuji Intelligent Feeder Manual.”

Tape feed speed switch

Tape type changeover switch

Feed pitch setting switch

LED lamp

Forward button

Origin button

Reverse button

Cover tape feed button