00196715-01_IM_SSW_704_DE_EN.pdf - 第48页
Installation Manual, Station Software Version 704.01 04/2010 Edition 7.2 SX1/SX2 placement machine For the SX1/SX2 placement machine the follo wing window is displayed, in which the Manual selection required note informs…
Installation Manual, Station Software Version 704.01 04/2010 Edition
→ Click the Machine service button and enter the password to change into this activity level.
7.1 X-series placement machines
The following window is displayed for the X-series machines. Here you can edit, confirm or reject the Auto-
configuration.
Fig. 7-4: Confirming Auto-configuration for X-series
→ Click the Confirm changes and continue startup button to confirm the Auto-configuration.
47 of 60
Installation Manual, Station Software Version 704.01 04/2010 Edition
7.2 SX1/SX2 placement machine
For the SX1/SX2 placement machine the following window is displayed, in which the Manual selection
required note informs, that the table configuration has to be selected manually, as this is not detected
automatically.
Fig. 7-5: Selecting table configuration
→ Click the ? question mark next to Location 2.
The selectable table configurations are displayed.
Fig. 7-6: Possible table configurations
→ Select a table configuration with or .
→ Click the Accept button.
48 of 60
Installation Manual, Station Software Version 704.01 04/2010 Edition
→ Repeat the steps for Location 1.
When you have selected all table configurations the following window is displayed, in which you confirm
the Auto-configuration.
Fig. 7-7: Confirming Auto-configuration for SX1/SX2
→ Click the Confirm changes and continue startup button to confirm the Auto-configuration.
7.3 SX+ placement machine
If the SX+ placement machine is to be used without gantries, this has to be configured in the Auto-
configuration after the machine has been booted. For this you have to select "Ignore gantries" at the
processing area in the machine configuration dialog.
7.4 SX4 placement machine
When the SX4 placement machine is booted for the first time you have to select the "SX4 High Speed"
entry for "Machine frame" manually in the Auto-configuration, if there are tables in outer position in
processing area 2, as this is not detected automatically via sensors. Tables in outer position are used
when stationary cameras are in use. Otherwise you select the "SX4 Speed" entry.
49 of 60