00198532-01_SM_MeasurementFeeder_EN.pdf - 第11页

2 Replacing spare parts 2.2 Front sliding guide / sliding foil Service Manual SIPLACE MeasurementFeeder X 02/2020 11 2.2.2 Fitting the Front Sliding Guide NOTICE The pickup window must be fitted To prevent damage to the …

100%1 / 30
2 Replacing spare parts
2.2 Front sliding guide / sliding foil
10 Service Manual SIPLACE MeasurementFeeder X 02/2020
2.2.1 Removing the Front Sliding Guide
NOTICE
The pickup window must be fitted
To prevent damage to the sprocket wheel and the reject device, make sure that the pickup
window is fitted for this work.
► Turn the feeder module so that its underside is at
the top.
► Place the sliding foil remover into the sliding
guide, as shown in the diagram.
► Lever the sliding foil out of the engaged position.
► Lever the sliding foil until it has been turned by
approximately90°.
► Push the sliding foil towards the front and out of
the sliding guide.
► Loosen the 2 screws.
► Lift the sliding guide off the feeder module.
2 Replacing spare parts
2.2 Front sliding guide / sliding foil
Service Manual SIPLACE MeasurementFeeder X 02/2020 11
2.2.2 Fitting the Front Sliding Guide
NOTICE
The pickup window must be fitted
To prevent damage to the sprocket wheel and the reject device, make sure that the pickup
window is fitted for this work.
► Insert the sliding guide - as shown in the diagram
- into the groove on the drive carrier.
► Position the front sliding guide so that you can
see the holes for the screws through the sliding
guide.
► Fix the sliding guide to the feeder module with
the 2 Phillips head screws (M3x10mm).
► Press the sliding foil slightly together.
► Push the sliding foil from the front into the sliding
guide, until it engages audibly.
2 Replacing spare parts
2.3 Rear sliding Guide
12 Service Manual SIPLACE MeasurementFeeder X 02/2020
2.3 Rear sliding Guide
Required spare part
Fig.2: Sliding guide, back
Feeder module Item no. Designation
MeasurementFeederX 03003994-xx
03119317-xx
00328251-xx
Sliding guide / back L200
ISO 14585 - ST2.9x9.5-F-St,FeZn (3x)
SN 213307-H-M2.5 x 8-A2-70 (1x)
Required tools
●
TORX screwdriver 0.6 Nm, size T8