MPM UP3000中文操作手册.pdf - 第33页
Please DEFINE the END pad of this device. (請將 PAD 點前後框起來) Press NEXT to alternate between POSITION (按 NEXT 調整框位置、尺寸) Adjust mode and size adjust mode. Press EXIT when you are FINISHED. (按 EXIT 完成) JOG to the closest Vert…
Press SELECT
按 SELECT 之後,出現下列訊息視窗畫面
Teach Board 依照板子上零件來製作程式 2D 檢查零件
Teach Stencil 依照鋼板上零件來製作程式 2D 檢查零件
OK 決定選用板子或鋼板
Cancel 不要製作 2D 檢查零件
※ 一搬選用板子時，需確認鋼板開孔是否為1：1比例，不然會檢驗不過
按 OK 之後,出現下列訊息視窗畫面
JOG to the closest Horizontal end pad. (移動虛線,選擇 QFP 第一點水平
The object should be centered. PAD 點)
Press EXIT when you are FINISHED. (按 EXIT 完成)
32
Please DEFINE the END pad of this device. (請將 PAD 點前後框起來)
Press NEXT to alternate between POSITION(按 NEXT 調整框位置、尺寸)
Adjust mode and size adjust mode.
Press EXIT when you are FINISHED. (按 EXIT 完成)
JOG to the closest Vertical end pad. (移動虛線,選擇 QFP 第一點垂直
The object should be centered. PAD 點)
Press when you are FINISHED. (按 EXIT 完成)
33
Please DEFINE the END pad of this device. (將 PAD 點前後框起來)
Press NEXT to alternate between POSITION(按 NEXT 調整框位置、尺寸)
Adjust mode and size adjust mode.
Press EXIT when you are FINISHED. (按 EXIT 完成)
※ 按 EXIT 之後,影像視覺系統自動搜尋 QFP，並計算零件腳數量
選擇 DIL 零件時之後,出現下列訊息
JOG to the End Pad of either row. (移動虛線中心點到PAD點，前起始點
The object should be centered. 與後結束點，兩邊都可)
Press EXIT when DONE. (按EXIT完成)
JOG to the Nearest End Pad of the other row. (移動虛線中心點到另一邊PAD點
The object should be centered. ，前起始點與後結束點皆可)
Press EXIT when DONE. (按EXIT完成後，影像系統自動搜尋完成後存檔)
※ DIL零件腳，先定義一邊PAD點再定義另一邊PAD點
選擇 SIL 零件時之後,出現下列訊息
JOG to the END PAD of DEVICE (移動虛線中心點到PAD點，前起始點與
The object should be centered. 後結束點皆可)
Press EXIT when DONE. (按EXIT完成後，影像系統自動搜尋完成後存檔)
※ SIL零件，須定義一邊腳位置即可
34