00194610-01.pdf - 第25页
Retrofit instructions: Modification of the nozzle changer power supply for the DLM placement heads, HF series 07/2005 Edition 25 : Attach th e new cable to the connector: additional white at pin 1, brown at pin 2. 2 2 : …
Retrofit instructions: Modification of the nozzle changer power supply for the DLM placement heads, HF series
07/2005 Edition
24
: Remove the cover from the connector.
: Pull the cable through the rear strain relief on the connector.
2
2
: Use a size 0 or smaller screwdriver to open the connector.
Insert the screwdriver as far as it will go (approx. 13 mm) and lever out the bar.
2
2
Strain relief
Retrofit instructions: Modification of the nozzle changer power supply for the DLM placement heads, HF series
07/2005 Edition
25
: Attach the new cable to the connector:
additional white at pin 1,
brown at pin 2.
2
2
: Tighten the screws of the strain relief.
: Fit the cover onto the connector.
: Connect the connector to its counterpart and pack the two connectors into the machine frame.
2
: Carry out this conversion at all the locations at which a C&P placement head with nozzle
changer is installed.
2
2
2
2
2
2
white at pin 1 (additional)
brown at pin 2
Retrofit instructions: Modification of the nozzle changer power supply for the DLM placement heads, HF series
07/2005 Edition
26
: Remove the side panels from the main and sub-distributors (locations 2 and 4).
2
: Remove the black 4-pin connector.
2
2
2
2
2
2
2
2