00191474-02.pdf - 第21页
Retrofit instructions HS -50 Cable mounting plate on the head board 1 1/99 edition 21 5 Fig. 5 - 1 Dismantling the head board and fixing part s 5 5 5
Cable mounting plate on the head board Retrofit instructions HS -50
11/99 edition
20
–Position IV
M3x5 fillister head screw, DIN 912, item 7
M3x14 spacer bolt, (internal thread, external thread), item 11
M3x15 spacer bolt, (internal thread, internal thread), item 12
M3 washer, DIN 9021, item 13
M3x5 spacer bolt, (external thread, external thread), item 15
M3 washer, DIN 433, item 4
M3 nut, DIN 934, item 5
5 Dismantling the head board and old fixing parts
Å Detach all the cables from the head board.
Å Loosen the nuts (see Fig. 5 - 1).
Å Carefully pull the head processor board (item 2 in Fig. 5 - 1) away from the plugs.
CAUTION 5
Make sure that the head processor board does not become jammed while you are removing
it since this could bend the pins. 5
Å Loosen the M3x15 spacer bolts (item 3 in Fig. 5 - 1).
Å Carefully pull the head board (item 2 in Fig. 5 - 1) away from the spacer bolts.
Å Loosen the M3x35 spacer bolts (item 4 in Fig. 5 - 1).
Å Loosen the M3x10 spacer bolt (item 5 in Fig. 5 - 1).
Key to Fig. 5 - 1
(1) C50 head board, item no. 00331451-02
(2) C51 head board, processor, item no. 00331452-02
(3) M3x15 spacer bolt
(4) M3x35 spacer bolt, 3x
(5) M3x10 spacer bolt
(6) DLM1 revolver head
(7) Velcro fastener for the positioning unit ribbon cable (z axis up)
Retrofit instructions HS -50 Cable mounting plate on the head board
11/99 edition
21
5
Fig. 5 - 1 Dismantling the head board and fixing parts
5
5
5
Cable mounting plate on the head board Retrofit instructions HS -50
11/99 edition
22
6 Attaching the Velcro fasteners and round cable
holder to the component vision module
Å Clean the adhesive surfaces of the revolver head identified by item 7 in Fig. 5 - 1 and item 1 –
4 in Fig. 6 - 1 using a clean, lint-free cloth moistened with ethyl alcohol.
PLEASE NOTE: 6
The adhesive surface must be free of oil and grease. 6
Å Remove the protective film from the adhesive surfaces of the Velcro fasteners.
Å Place the Velcro fasteners at the indicated points on the revolver head (item 7 in Fig. 5 - 1 and
item 1 – 3 in Fig. 6 - 1) and press down lightly.
Å Remove the protective film from the side of the Velcro fastener facing the ribbon cable.
CAUTION 6
Use your index finger and press the ribbon cable only lightly against the adhesive surfaces.
Otherwise you may break the cable, which would cause faults in the revolver head. 6
Å Remove the protective film from the adhesive surface of the round cable holder and press
down lightly to fix it to item 4 in Fig. 6 - 1.
Å Snap the vacuum hose into the clip of the round cable holder.