00196678-0102_RI_CAN-Knoten_X-Serie70x_De+EN.pdf - 第50页
Installation Running the CAN Nodes Option Cable 50 Retrofit Instructions CAN Node X Series SW70x 6.3 Running the CAN Nodes Option Cable NOTE: In placement ar eas with only one gantr y, the comp onent trolley feed-in devi…
Installation
Replacing the Tape Cutter Control Board with the CAN Nodes
Retrofit Instructions CAN Node X Series SW70x
49
See also CAN nodes. (5.4 Control Unit on Tape Cutter (CAN Node Module)
J
43)
(1) X1: cable: power CAN nodes NC/TC
[03047464-xx]
(2) X13: cable of feed-in device for X series: NC CAN nodes
NC row 1 [03053225-xx]
(3) X3: cable feed-in device X series: reject
bin [03053229-xx]
(4) X14: cable of feed-in device for X series: NC CAN nodes
NC row 2 [03053225-xx]
(5) X12: cable of feed-in device for X series:
nozzle station [03053223-xx]
Installation
Running the CAN Nodes Option Cable
50 Retrofit Instructions CAN Node X Series SW70x
6.3 Running the CAN Nodes Option Cable
NOTE:
In placement areas with only one gantry, the component trolley feed-in device is fitted in the
innermost position of location 2 or 4. In this case, the component trolley feed-in device needs to
be pulled out slightly. In placement areas with only one gantry, the component trolley feed-in
device is fitted in the innermost position of location 2 or 4. In this case, the component trolley
feed-in device needs to be pulled out slightly. Please read the service manual for the X series
prior to this.
When fitting, first tighten the fitting screw and then the screws on the inner side of the machine.
6-6: Cable routing for CAN nodes to back of component trolley feed-in device
X Route the cable from the CAN nodes along the
existing cable tree to the back of the
component trolley feed-in device and fix in
place with cable ties.
6-7: Cable routing for CAN nodes to back of component trolley feed-in device
X Run the option cables to the back of the
component trolley feed-in device. The cables
must be routed under the cover plate (5).
X Run the option cables and fix in place with
cable ties.
(1) Cable of feed-in device for X series: nozzle
station [03053223-xx]
(2) Cable feed-in device X series: reject bin
[03053229-xx]
(3) Cable of feed-in device for X series: NC
CAN nodes NC row 1 [03053225-xx]
(4) Cable of feed-in device for X series: NC
CAN nodes NC row 2 [03053225-xx]
Installation
Running the CAN Nodes Option Cable
Retrofit Instructions CAN Node X Series SW70x
51
6-9: Circuit diagram for 1 wire hub module [03041473-xx]
6-8: Removing the 1 wire hub module [03041473-xx]
X Remove the 1 wire hub if still present and
connect the new cables to the options fitted.
See also Reject bin query SIPLACE X series /
D3, issue 11/2006 [00194716-02]. or Assem-
bly instructions for nozzle changer CPP/
C&P20A (from SW 702) SIPLACE X series, is-
sue 06/2009 [00196432-01]
(1) Patch cable [03041326-xx] to 1 wire distributor
[03040219-xx]
(2) 1 wire hub module [03041473-xx]
(3) Cable to nozzle changer (4) Cable for component reject bin query