SOM-1764-001.pdf - 第11页

6. Re-starting Operation 031 1-001 10 Tg0979-PM-SO 6. Re-starting Operation When the [ST ART] button is pressed, the operation is re-started. When the [ST ART] button is pressed while "T otal number of produced Unit…

(a) It is not an actual error, but it is used to alert the operator.

(b) When the specified number of Unit P.C.B.s to be pro-

duced is reached and the machine is stopped, then a

recovery operation is needed, such as removing the

P.C.B.s on the input/transfer conveyor in the main ma-

chine.

duced has been reached, then the Unit P.C.B.s without

component placement on the final P.C.B. are counted as

defective Unit P.C.B.

5. End of Production

0311-001 9 Tg0979-PM-SO

5. End of Production

When the production of the final P.C.B. is completed, it is announced on

the Error Window that the specified number has been reached (Fig. 4).

Fig. 4

Note

6. Re-starting Operation

0311-001 10 Tg0979-PM-SO

6. Re-starting Operation

When the [START] button is pressed, the operation is re-started.

When the [START] button is pressed while "Total number of produced

Unit P.C.B.s is more than specified number of Unit P.C.B.s to be pro-

duced" is shown, then the operation can not be re-started on the

"CHECK" window in Fig. 5.

• In that case, either the "P.C.B. Counter" should be cleared to "0" or

the "Product PCB Set Mode" should be set to "Disable" on the

"P.C.B. COUNTER DETECTION MODE" window (Fig. 1).

Fig. 5

(a) When the semi-automatic start/Warm start is used, the

alarm is not available.

The recovery operation due to the operation stop is

allowed.

(b) When the automatic operation is manually stopped or the

semi-automatic operation is set, then manual recovery by

the operator is required because the number of Unit

P.C.B.s (number of components to be placed) has not

been obtained.

Note

0311-001 11 Tg0979-PM-SO