TX系列贴片机机台半年保养手册.pdf - 第42页
12 WF 3 TX-Series Maintenance Maintain the tape cutter 15 min 4 / 4 C A U T I O N ! R e f e r t o s a f e t y i n s t r u c t i o n s i n u s e r m a n u a l b e f o r e c o m m e n c i n g M a i n t e n a n c e Machin…
12 WF 3 TX-Series Maintenance Maintain the tape cutter 15 min 3 / 4
CAUTION! Refer to safety instructions in user manual before commencing Maintenance
Machine Status OFF Conveyor Empty
NOTICE! ESD guidelines are to be followed Tool:
T31, T34, T56, T89, T90
Wear Part: Consumables:
C03, C26, C31, C49
www.asm-smt.com
13 Remove the waste slide. 14 Position the grease gun at the nipple (1). 15 Press the trigger till grease comes out.
16 Remove any excess grease from the
nipple.
17 Repeat steps 14 to 16 at the other side of
the cutter.
18 Put grease on a brush.
12 WF 3 TX-Series Maintenance Maintain the tape cutter 15 min 4 / 4
CAUTION! Refer to safety instructions in user manual before commencing Maintenance
Machine Status OFF Conveyor Empty
NOTICE! ESD guidelines are to be followed Tool:
T31, T34, T56, T89, T90
Wear Part: Consumables:
C03, C26, C31, C49
www.asm-smt.com
19 Distribute the grease to the fixing blade
over the whole length.
20 Remove any excess grease from both
sides of the blade.
21 Return the waste slide and fasten the
screws on both sides (1 and 2).
22 Repeat all steps on the other tape cutter.
13 WF 3 TX-Series Maintenance Check / replace the vacuum pump filter disk 4 min 1 / 2
CAUTION! Refer to safety instructions in user manual before commencing Maintenance
Machine Status OFF Conveyor Empty
NOTICE! ESD guidelines are to be followed Tool:
T86
Wear Part:
W31
Consumables:
C19
www.asm-smt.com
1 Location of the vacuum pump. 2 Open and remove the panel. 3 Open the edgewise retaining clamp (1)
and remove the cap.
4 Remove the vacuum filter. 5 Clean the vacuum filter. 6 If OK go to step 8.