TM5739.Insertion-Component_SimpleVisionAlgorithmSetting.pdf - 第8页
SMT Software En gineering G rou p IM Ope rations Y A M A HA MOTOR CO., L TD. MDO C-SOFT 50229 8/12 (3) T ap [Parts] - [Pa rt sAdj ] - [P in Position] button and open ”Pin Position Edit” sc reen, a nd set pin pos…
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50229 7/12
Fig.5 Setting of “Pin Pos Tolerance”
Fig.6 Setting of “Check Direction”
Detection circle
Point symmetry area around the parts
center of detection circle
(When “Check Direction” is “2 Angle”)
Compare average brightness
in both. (Check Type)
“Dir Mark
Diameter”
“Dir Mark Center Y”
“Dir Mark Center X”
Theoretical pin position
calculated by parts center
Pin detection position
Pin Pos Tolerance
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50229 8/12
(3) Tap [Parts] - [PartsAdj] - [Pin Position] button and open ”Pin Position Edit” screen, and
set pin position data.
Fig.7 [Parts] – [Parts Adj] screen
Fig.8 [Parts] - [Parts Adj] - [Pin Position Edit] screen
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
MDOC-SOFT50229 9/12
In editor, tap [Edit] - [Pin Position Edit] of menu (Or, ”Pin Position Edit” button at toolbar)
and open ”Pin Position Edit” screen.
Fig.9 Editor
Fig.10 [Pin Position Edit] screen of editor