M4serviceManual_e.pdf - 第17页

1 Installation 1-9 Supplementary Explanation for Installation When setting up a production line, level adjustment a nd line positioning of the machine m ay be carried out at the same time. However, to fine-adjust the mac…

1 Installation

1-8

④ After the machine is adjusted level, check again that the transfer height is correct, and then lock each

adjust foot nut.

NOTE: The adjust foot nuts must be locked with a closed wrench (nominal: 46mm).

⑤ The head assy. is fixed to the XY shafts with nylon ties. Take them off with nippers.

⑥ Connect the power cable and ground line independently of other machines which may be a noise

source, such as a compressor, welding machine.

⑦ Connect an intake-side air coupler 65SN or 85SN (Nitto Kohki) or equivalent to the air regulator

coupler located on the rear of the machine. After the coupler is connected, make sure that the air

regulator’s reading is 0.5MPa(5.1 ㎏ f/c ㎡).

Intake-side air coupler

65SN/85SN (Nitto Kohki) or equivalent

Air regulator

Air coupler

1 Installation

1-9

Supplementary Explanation for Installation

When setting up a production line, level adjustment and line positioning of the machine may be carried out

at the same time. However, to fine-adjust the machine position with the machine level, i-PULSE

recommends that the machine be roughly positioned to the production line first, and then be leveled and

positioned accurately using the following four sets comprising a hydraulic jack and plates.

ACTION:

① Apply grease between base plates 1 and 2 for lubrication purposes.

② Place a plate set near each machine jack-up point (four points).

③ Place a jack on each plate set and jack up the machine.

④ Adjust each jack so that the machine is level.

⑤ Fine-adjust the position of the machine while the machine is jacked up. (The machine can be moved

lengthwise and crosswise with help of grease applied between the plates.)

Hydraulic jack

Base plate 1

Base plate 2

Apply grease

between the

lates.

Hook stroke

1 Installation

1-10

NOTE: The machine cover must be removed while jacking up the machine

NOTE: The hydraulic jacks must satisfy the following requirements.

Allowable load: 1.5 tons or higher

Hook size: 100mm or more (stroke)

Part Name

Part No. Remark

PLATE,BASE LG0-M8911-00X For plates 1 and 2

Jack-up point

(enlarged view)

Jack-up point

Four points (two each at

front and rear)