M4serviceManual_e.pdf - 第18页

1 Installation 1-10 NOTE: The machine cover must be rem oved while jacking up the machine NOTE: The hydraulic jacks m ust satisfy the followi ng requirements. Allowable load: 1.5 tons or hi gher Hook size: 100mm or more …

1 Installation

1-9

Supplementary Explanation for Installation

When setting up a production line, level adjustment and line positioning of the machine may be carried out

at the same time. However, to fine-adjust the machine position with the machine level, i-PULSE

recommends that the machine be roughly positioned to the production line first, and then be leveled and

positioned accurately using the following four sets comprising a hydraulic jack and plates.

ACTION:

① Apply grease between base plates 1 and 2 for lubrication purposes.

② Place a plate set near each machine jack-up point (four points).

③ Place a jack on each plate set and jack up the machine.

④ Adjust each jack so that the machine is level.

⑤ Fine-adjust the position of the machine while the machine is jacked up. (The machine can be moved

lengthwise and crosswise with help of grease applied between the plates.)

Hydraulic jack

Base plate 1

Base plate 2

Apply grease

between the

lates.

Hook stroke

1 Installation

1-10

NOTE: The machine cover must be removed while jacking up the machine

NOTE: The hydraulic jacks must satisfy the following requirements.

Allowable load: 1.5 tons or higher

Hook size: 100mm or more (stroke)

Part Name

Part No. Remark

PLATE,BASE LG0-M8911-00X For plates 1 and 2

Jack-up point

(enlarged view)

Jack-up point

Four points (two each at

front and rear)

1 Installation

1-11

Connecting Loader with Machine

There is an entrance sensor at the entrance of the machine. If the loader is installed upstream of the

machine, the entrance sensor must be moved to avoid interruption with the loader.

After the sensor has been moved, align the conveyors for smooth board transfer.

NOTE: While moving a sensor and aligning conveyors, the power to the machine must be turned off.

a: The sensor position without a loader.

b: The sensor position with a loader installed upstream of the machine.

Loader rack

Loader’s frame

Normal position

Entrance Sensor

Position with loader installed