YG12F_Ope_E.pdf - 第86页
2-28 2 asic operation Route the tape to the path described below. c T ape path dra wing Carrier tape Porti…
2-27
2
asic operation
4
Lift the tape guide.
Hold down the front side restraint lever and lift the tape guide.
Tape guideTape
Tape guide
Front side restraint lever
23207-M7-00
5
Set the tape in the tape feeder.
Pass the tape through the groove.
Pull out some portion of the tape beforehand so that the top tape can reach the idle roller assembly.
Pass the top tape through the notch of the tape guide and fold it back.
Setting the top tape
Top tape
Tape guide notch
Idle roller assembly
23208-M7-00
n
NOTE
“Feeder User’s Manual” explains how to set a tape in details.
2-28
2
asic operation
Route the tape to the path described below.
c
Tape path drawing
Carrier tape
Portion AA
Top tape
E
A – E : Top tap
a – c : Carrier tape
A
a
c
C
B
b
D
D
In case of FS2
23209-M7-00
n
NOTE
Tape path of FT and that of FS2 are the same.
6
Transfer components to the pickup position.
When the tape is set, press the bend portion of the cover tape peeling lever to transfer components to
the pickup position.
2-29
2
asic operation
3. Installing the feeder on a mounter
Follow the instructions below to install the feeder on a mounter.
1
Check the feeder set position.
Press the [Setup] - [Setup List] button and check the feeder set position in the “Setup List” screen.
Setup List
24218-M7-00
e
2
Press the emergency stop button.
Press the emergency stop button on the mounter to stop mounter operation.
c
Installing a feeder unit without stopping the mounter might cause items to be entangled in machine.
3
Clean the surface of the feeder plate.
Parts or debris caught in the machine will tilt the feeder, interfering with stable pickup.
Removal of foreign material on the feeder plate
23210-M7-00