manual-pedal-P005-0028920_ID-223540.pdf - 第9页

P005 P105 P305 P405 POR T 2 PERIPHER ALS F AE/ R OBO T POR T 1 DDU www .jbctools. com 1 2 3 SW1 P305 C ongur a tion S wit ch SUPPOR T C ONNEC TION PED AL ST A TION T OOL PORT 2 PERIPHERALS FAE/ ROBOT P ORT 1 DDU MSE www…

100%1 / 12
8
Pedal Set Up for AL (Auto Feed Soldering Station)
The choosed wire dispensing operation mode will be applied for the tool button as well as for the
pedal activation.
The working mode can be switched to:
- Continous: Solderwire is being fed constantly as long as the pedal or the tool button is activated.
- Discontinous: A predetermined solder wire amount is being fed every time the pedal or tool button
is being pressed.
Navigate throug the menu by pressing , use or to change the value. Confirm the
selection by pressing .
P005
P105
P305
P405
PORT 2
PERIPHERALS
FAE/
ROBOT
PORT 1
DDU
www.jbctools.com
1 2 3
SW1
P305
Conguration
Switch
SUPPORT
CONNECTION
PEDAL
STATION
TOOL
PORT 2
PERIPHERALS
FAE/
ROBOT
PORT 1
DDU
MSE
www.jbctools.com
STATION
TOOL
9
Tool
Control Unit
1
Example:
Chip Compoments Rework Process using Tweezers and Pedal
Pedal
Connections
Connect the stand and the module to to the control unit. The Tool must be connected to the stand.
Then connect pedal P005 to the module.
In the peripherals menu for the “Pedal Activation Mode” choose between “pressed” and “released” for
the pedalactivation mode (see page 5).
The Pedal is frequently used to rework components with tweezers.
The adjustable micro tweezers of the AM120 JBC not only provide a perfect solution for SMD chip
components and small/medium SOP of PCB assemblies, but also facilitate their quick placement and
soldering using the P005 pedal.
Module
Stand
40 mm
50 mm
60 mm
80 mm
100 mm
130 mm
130 mm
para manuales - color gris
200 mm
300 mm
10
3
4
Pad Cleaning
Clean the pads with JBC´s desoldering tool
DS360.
For this operation JBC´s desoldering station
DSS is needed.
Solder Paste Dispensing
Apply the solder paste amount needed to
solder the new chip component.
The use of JBC´s DPM solder paste dispenser
is recommended.
DPM
Manual
Solder Paste Dispenser
DS360
Micro
Desoldering Iron
Desoldering*
Lift the tool from the holder, press and hold
the pedal to activate the tool and desolder the
component.
Once the pedal is released the tool enters in
hibernation mode and cools down.
2
* “Press Mode” previously selected