TM1609_Explanation to Make the Compatibility between Old 311A-311F Nozzle and New Nozzle.pdf - 第10页
SMT Software Engineeri ng Group IMOperationsYAMAHAMOTORCO. ,LTD. MD OC-SOFT50041 10/10 5. Notes 5.1. Nozzle Interference Ch eck (Y .FacT P-T oo l) The risk of the interference of m ounted parts a…
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50041
8/10
When the following screen is displayed in the version up process, please continue the work
with the check mark on “Update of Nozzle Spec”.
As a result, the necessary following informations are reflected in Y.FacT P-Tool to make the
compatibility of 311A/311F nozzle.
[Setting] – [Specification Information] – [Mount Nozzle Specification]
[Setting] – [Specification Information] – [Side View Camera Spec]
* The information set for the special nozzle is not lost, because the information of
Type-31A to Type-31Z for the special nozzle is not overwritten,
* When the information of Type-311 to Type-319 for the standard nozzle have beenn
changed
from the initial settings, it is necessary to re-resister machine as shown in 4.2 .
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50041
9/10
4.2. Re-Register Machine
Because the information updated here does not contribute to making the board data and
optimization, this work can be omitted. But when the information of Type-311 to Type-319 for
the standard nozzle have beenn changed from the initial settings in machine, this work is
necessary.
Please re-register machine to Y.FacT P-Tool by using system backup obtained from the
machine that has been finished the work to make the compatibility of 311A/311F nozzle.
As a result, the necessary following information is reflected in Y.FacT P-Tool to make the
compatibility of 311A/311F nozzle.
[Setting] – [Specification Information] – [Side View Camera Spec]
Please do the above work to all the registered machines which need to make the
compatibility of 311A/311F nozzle.
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50041
10/10
5. Notes
5.1. Nozzle Interference Check (Y.FacT P-Tool)
The risk of the interference of mounted parts and nozzles is caused, because the new 311
nozzle diameter has been larger by changing the nozzle shape.
The already existing board data (especially in the board data that high-density mounting would
be executed) is strongly recommended to execute the “Nozzle Interference Check” again as
follows and to execute the “Optimization” again if necessary, after the work of chapter 4. “Setup
Steps in Y.FacT P-Tool”.