TM1609_Explanation to Make the Compatibility between Old 311A-311F Nozzle and New Nozzle.pdf - 第8页
SMT Software Engineeri ng Group IMOperationsYAMAHAMOTORCO. ,LTD. MD OC-SOFT50041 8/10 W hen the following scr een is displayed in t he version up process, please continue the work with the check …
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50041
7/10
4. Setup Steps in Y.FacT P-Tool
Setup steps in Y.FacT P-Tool to make the compatibility of 311A/311F nozzle are as following.
1. Software Version Up
(Update the information of Mount Nozzle Specification)
2. Re-Register Machine
(Update the information of Side View Camera Spec)
* When Y.FacT P-Tool is not used, the work of this chapter is unnecessary.
4.1. Software Version Up
The function to make the compatibility of 311A/311F nozzle is supported from the following
software versions, so please do software version up when the software that is older than the
following versions is installed.
when the following version has been already installed, it is unnecessary to do the work
mentioned on this document. Please do the work from "4.2 Re-Register Machine".
Table4.1 Target Model and Target Version Corresponding to the Function of Making
Compatibility of 311A/311F Nozzle
Item Object
Target Model Y.FacT P-Tool
Target Version V1.10 STD R1.000 or later
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50041
8/10
When the following screen is displayed in the version up process, please continue the work
with the check mark on “Update of Nozzle Spec”.
As a result, the necessary following informations are reflected in Y.FacT P-Tool to make the
compatibility of 311A/311F nozzle.
[Setting] – [Specification Information] – [Mount Nozzle Specification]
[Setting] – [Specification Information] – [Side View Camera Spec]
* The information set for the special nozzle is not lost, because the information of
Type-31A to Type-31Z for the special nozzle is not overwritten,
* When the information of Type-311 to Type-319 for the standard nozzle have beenn
changed
from the initial settings, it is necessary to re-resister machine as shown in 4.2 .
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50041
9/10
4.2. Re-Register Machine
Because the information updated here does not contribute to making the board data and
optimization, this work can be omitted. But when the information of Type-311 to Type-319 for
the standard nozzle have beenn changed from the initial settings in machine, this work is
necessary.
Please re-register machine to Y.FacT P-Tool by using system backup obtained from the
machine that has been finished the work to make the compatibility of 311A/311F nozzle.
As a result, the necessary following information is reflected in Y.FacT P-Tool to make the
compatibility of 311A/311F nozzle.
[Setting] – [Specification Information] – [Side View Camera Spec]
Please do the above work to all the registered machines which need to make the
compatibility of 311A/311F nozzle.