00197382-01_IM_SetupCenter6.0_EN.pdf - 第85页
Installation 4.4.4 Datalogic Scanner Connection Steps to Perform After Installation Installation Manual SIPLACE Setup Center 6.0 85 ► The scan ner-ID is no w increment ed to the ne xt unused address. A ctivate the next S…
Installation
Steps to Perform After Installation 4.4.4 Datalogic Scanner Connection
84 Installation Manual SIPLACE Setup Center 6.0
4.4.4.1
4.4.4.1 Narrowband Scanner
Narrowband Scanner
By first configuration of a scanner by this Setup Center, the cradle address is set by random.
► Click the barcode trigger-key on scanner one time to activate it from standby-mode.
► Put the scanner into the cradle and click “Start” to set up the scanner.
By first configuration the cradle is unknown for Setup Center.
► Validate the message with “Yes” to continue.
► Remove the scanner from cradle and press the “Enter”-key on scanner to check the connection to
Setup Center.
► Click “Yes” to connect another scanner with Setup Center.
CAUTION
Configure each scanner again, if you moved the cradle from another Setup Center computer.
Installation
4.4.4 Datalogic Scanner Connection Steps to Perform After Installation
Installation Manual SIPLACE Setup Center 6.0 85
► The scanner-ID is now incremented to the next unused address. Activate the next Scanner from
standby, put it into cradle and click “Start”.
If you manually enter an already used address, Setup Center will warn you by following.
CAUTION
Do not scan or press keys at an already connected scanner, while configuring a new one.
CAUTION
Make sure that the cradle address and scanner-ID are unique in a factory.
CAUTION
It’s not recommended to move a cradle from one Setup Center Computer to another. In this
case, please configure each scanner again.
Installation
Steps to Perform After Installation 4.4.4 Datalogic Scanner Connection
86 Installation Manual SIPLACE Setup Center 6.0
Changing the Cradle Address
If you want to change the cradle address in the future, you should notify that all previously connected
scanners will be disconnected. You have to reconfigure them again.
► Click “Start” to continue.
► Click “Yes” to confirm the change.