00197396-02_AI_Serviceflap_X-Series_S_DE_EN.pdf - 第44页
3 Installation 3.3 Converting the Side Cover 44 Assembly Instructions / Montageanleitung SIPLACE X-Series S Service Flap Serviceklappe 07/2019 3.3 Converting the Side Cover Fig.9: Converting the side cover ► Place the s…
3 Installation
3.1 Preparatory Steps
Assembly Instructions / Montageanleitung SIPLACE X-Series S Service Flap Serviceklappe 07/2019 43
3 Installation
Installation of the service flap consists in principle of the following steps:
●
3.2 "Removing the Side Cover" [}43]
●
3.3 "Converting the Side Cover" [}44]
●
3.4 "Fitting Hinges and Sliders" [}45]
●
3.5 "Fitting the Security Switch" [}46]
●
3.6 "Fitting the Service Flap" [}47]
3.1 Preparatory Steps
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation.
1.2 "Preparatory work..." [}33]
3.2 Removing the Side Cover
Fig.8: Removing the side cover
► Remove the three captive screws (1).
► Pull the side cover forwards and out (2).
► Remove the bolts at (3) and (4).
3 Installation
3.3 Converting the Side Cover
44 Assembly Instructions / Montageanleitung SIPLACE X-Series S Service Flap Serviceklappe 07/2019
3.3 Converting the Side Cover
Fig.9: Converting the side cover
► Place the side cover down on a suit-
able work surface.
► Fasten the actuating bracket for the
safety switch using two screws(1).
► Fasten the handle with two screws(2).
Handle assy SIPLACE X-Series S
for locations 1 / 3 [03112951‑xx]
for locations 2 / 4 [03112952‑xx]
► Remove the reinforcements at (3)
and (4).
3 Installation
3.4 Fitting Hinges and Sliders
Assembly Instructions / Montageanleitung SIPLACE X-Series S Service Flap Serviceklappe 07/2019 45
3.4 Fitting Hinges and Sliders
NOTICE
Pay attention to the hinge version
Make sure that you use the correct hinges, as the retrofit kit includes both versions (left and
right): right for location 4 and 2, left for location 1 and 3.
Your hinges might vary somewhat. However, the assembly procedure is the same.
Fig.10: Fitting hinges and sliders
► Fasten the hinge at the top at the points marked (1) and (2) the EMC tape at the point marked (1).
Make sure that you use the correct variant for locations 1/3 and 2/4. Do not yet tighten the screws.
► Fasten the lower part of the hinge with two screws (4).
► Fasten the slider accordingly to "hinge top" (3) and "hinge lower part assy"(5).