Stopper ASE HS60.pdf - 第22页
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design) 11/2005 Edition 22 2.4 Deliverables – S topper adapter plate for conveyors with pressure sensor – Assembly rail – S topper modu le – S pacers M3 x 5 m…
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design)
11/2005 Edition
21
2 Retrofit Instructions: Stopper for
ASE SIPLACE HS-60 (special design)
2.1 Description of the functions
Installing a mechanical stopper module allows the processing area to be varied as required. The
conveyor firmware special design deactivates the light barrier in the placement area and inte-
grates the stopper module with sonar sensor. 2
The conveyor TSP firmware also takes account of the lifting table clamp for the ASE special de-
sign. 2
2.2 Requirements
2.3 Restrictions
– To calibrate the conveyor edges you have to remove the stopper module, because the mini-
mum conveyor width is about 52 mm.
– if you have a conveyor with pressure sensor you have to deactivate the sensor at conveyor
control TSP-301 switch S4 number 3.
Software:
SC 503.xx
Hardware:
HS-60, both transport modes
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design)
11/2005 Edition
22
2.4 Deliverables
– Stopper adapter plate for conveyors with pressure sensor
– Assembly rail
– Stopper module
– Spacers M3 x 5 mm
– Spacer washers 13 mm diameter
– Countersunk head screws M4 x 16 mm for TSP without pressure sensor
– Countersunk head screws M4 x 10 mm for TSP with pressure sensor
– Cable ties
– Cable clips
– Diskette with firmware version TS510446.HEX
2.5 Tools required
– Set of hexagon socket spanners
– Phillips screwdriver
– Set of fork wrenches
–Side cutter
– Hose pliers
2
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design)
11/2005 Edition
23
2.6 Safety instructions
WARNING
The safety instructions from the “Operational safety” chapter of the user manual and servicing in-
structions take precedence over these instructions. 2
The SIPLACE placement machines are supplied with mains voltage.
Consequently parts of these systems carry dangerous voltages! This voltage is present at certain
modules inside the machine base, even when the machine is switched off at the main power
switch.
Incorrect handling of the placement machine or touching live parts of the machine can result in
death or severe injury, and considerable damage to equipment.
BEFORE starting any work, shut down the operating system correctly, then switch the machine
OFF at the main power switch and disconnect from the main power supply. In addition, the com-
pressed air supply must be switched off at the compressed air unit's main valve in the machine
base and vented by actuating the needle valve on the compressed air unit.
There is DANGER for heart pacemaker wearers in the vicinity of the linear motors, as described
in detail in the "Special safety instructions for working in the vicinity of strong magnetic fields"
section of the user manual and service manual.
Always follow the accident prevention regulations, DIN or other standards and special safety
rules applicable in your country.
Pay attention to the information concerning residual voltages in the Operational Safety chapter.
Follow the ESD regulations as described in the operational safety section of the operating
instructions.
During the retrofit, always secure the machine to prevent access by other people and to prevent
it being switched on again. The procedure is described in the “Locking the machine…” section of
the user manual.
Working with the SITEST program further increases the risk of accident.
The SITEST program must only be used by authorized and trained personnel.
2
2.6.1 Definitions
2
Please note 2
2
2