Stopper ASE HS60.pdf - 第30页
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design) 11/2005 Edition 30 : Plug the signal wires into the c onveyor conver sion board 00359425-xx. 2 2 2 2 2 2 2 2 2 2 2 2 2 Connect the plug-in cont acts a…
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design)
11/2005 Edition
29
2.9 Connecting the signal wires
: Remove the cover over the conversion board on the intermediate belt.
2
2
2
2
2
2
2
2
2
2
2
2
Conversion board cover
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design)
11/2005 Edition
30
: Plug the signal wires into the conveyor conversion board 00359425-xx.
2
2
2
2
2
2
2
2
2
2
2
2
2
Connect the plug-in contacts as shown in the circuit diagram
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design)
11/2005 Edition
31
2.10 Running the cables
: Fit the compressed air connection and signal wires to the lifting table bed using cable clips.
2
2
: Run the compressed air connection and signal wires in the cable duct in the vicinity of the in-
termediate belt.
2
Make sure that there are no points the wires can rub. 2
2
2
2
2
2
Running the cables and hoses
Cable clips