Stopper ASE HS60.pdf - 第24页
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design) 11/2005 Edition 24 2.7 Inst alling the stopper 2.7.1 HS-60 with pressure sensor on the conveyor The adapter plate must be fitted in or der to inst all…
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design)
11/2005 Edition
23
2.6 Safety instructions
WARNING
The safety instructions from the “Operational safety” chapter of the user manual and servicing in-
structions take precedence over these instructions. 2
The SIPLACE placement machines are supplied with mains voltage.
Consequently parts of these systems carry dangerous voltages! This voltage is present at certain
modules inside the machine base, even when the machine is switched off at the main power
switch.
Incorrect handling of the placement machine or touching live parts of the machine can result in
death or severe injury, and considerable damage to equipment.
BEFORE starting any work, shut down the operating system correctly, then switch the machine
OFF at the main power switch and disconnect from the main power supply. In addition, the com-
pressed air supply must be switched off at the compressed air unit's main valve in the machine
base and vented by actuating the needle valve on the compressed air unit.
There is DANGER for heart pacemaker wearers in the vicinity of the linear motors, as described
in detail in the "Special safety instructions for working in the vicinity of strong magnetic fields"
section of the user manual and service manual.
Always follow the accident prevention regulations, DIN or other standards and special safety
rules applicable in your country.
Pay attention to the information concerning residual voltages in the Operational Safety chapter.
Follow the ESD regulations as described in the operational safety section of the operating
instructions.
During the retrofit, always secure the machine to prevent access by other people and to prevent
it being switched on again. The procedure is described in the “Locking the machine…” section of
the user manual.
Working with the SITEST program further increases the risk of accident.
The SITEST program must only be used by authorized and trained personnel.
2
2.6.1 Definitions
2
Please note 2
2
2
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design)
11/2005 Edition
24
2.7 Installing the stopper
2.7.1 HS-60 with pressure sensor on the conveyor
The adapter plate must be fitted in order to install the stopper module on the conveyor in an HS-
60 with pressure sensor. 2
2
2
2
Note the restrictions!! 2
2
: To fit, unscrew the two painted screws indicated on the inside of the machine.
2
Never loosen both pairs of screws at the same time. 2
2
2
Adapter plate
Loosen the painted screws on the inside of the machine
Retrofit Instructions: Stopper for ASE SIPLACE HS-60 (special design)
11/2005 Edition
25
: Screw the spacer into the holes that are now exposed.
2
2
: Fit the adapter plate onto the spacers.
2
Spacers
Adapter plate