00195427-02_AI_HeadReconfigKitsD1D2_DE+EN.pdf - 第61页

If this is not possible, you must disassemble the camer a again and proper ly move the threaded pins. No threaded pin ca n be hidden behind the camer a, since this may cause the camera to be mounted at an angle. 2 Assemb…

100%1 / 94
Assembly instructions Head Reconfiguration SIPLACE D1 / D2
Edition 03/2007
58
: Turn the "Caul for mark" (03039370-), so that the recess is located at the top left (see Fig.
2.7.2).
: Position the "Caul for mark" to coincide with the holes in the machine frame on the set screws.
2
Fig. 2.7.2 "Caul for mark"
If this is not possible, you must disassemble the camera again and properly move the threaded
pins. No threaded pin can be hidden behind the camera, since this may cause the camera to be
mounted at an angle. 2
Assembly instructions Head Reconfiguration SIPLACE D1 / D2
Edition 03/2007
59
: Also position the camera base on the set screws and fix both with 2 hexagon socket screws
DIN912 M6x35 - 8.8 (00845062-).
2
Fig. 2.7.3 Mount the camera base and tighten 4x
2
: Replace the setscrews with the screws.
2
2
: Pull the three connection cables for the IC camera out of the machine frame
(see 2.7.3).
2
2
2
2
2
2
Assembly instructions Head Reconfiguration SIPLACE D1 / D2
Edition 03/2007
60
: Connect the cable to the camera:
– CAN-Bus cable X10au (03050162-)
– Hotlink cable (camera bus) X3au (03042343-)
– Power supply X4au (03040347-)
DIP switch
Power supply
X4au (03040347-)
CAN-Bus cable
X10au (03050162-)
Hotlink cable
(camera bus)
X3au (03042343-)
2
Fig. 2.7.4 Connect 3 cables to IC camera
DIP switch configuration:
2
DIP switch Gantry
No. Function ON OFF 1
1 Bootstrap —
2Reset Off
3 Gantry ID 0 Off
4 Gantry ID 1 — Off
5 Code 1 Off
6 CAN terminator with without Off
7 CAN speed = 1 Mbit/s = 500 kbit/s On
8 Camera type IC camera FC camera On