00195427-02_AI_HeadReconfigKitsD1D2_DE+EN.pdf - 第75页
Assembly instructions Head Re configuration SIPLACE D 1 / D2 Edition 03/2007 73 2.8 Inst alling the Collect&Place placement head 2.8.1 Configuring the C&P head usi ng the machine conf iguration wizard : S tart SI…
Assembly instructions Head Reconfiguration SIPLACE D1 / D2
Edition 03/2007
72
2.7.10 Calibrate all heads and cameras:
: Calibrate the P&P Head, camera and nozzle changer.
: Carry out the head mapping, if necessary.
2
: Back-up the machine data.
2
: Restart again.
This completes the conversion. 2
2.7.11 Dismounting the P&P module
A standard D1 machine is converted into a D1 single head (with C&P placement head).) 2
The second placement head on the gantry is dismounted with
its nozzle changer and stationary
cameras and deactivated at SIPLACE Pro and SITEST. In detail the work is described above in
chapter "Mounting". 2
2
2
2
Assembly instructions Head Reconfiguration SIPLACE D1 / D2
Edition 03/2007
73
2.8 Installing the Collect&Place placement head
2.8.1 Configuring the C&P head using the machine configuration wizard
: Start SITEST and select "Settings—Machine Configuration".
: Enter in the machine configuration the new placement head, cameras (standard camera type
28 / optional FC camera type 29) and nozzle changer.
Save the result!
: Shut down the station computer and switch off the placement machine.
2Detailed instructions for configuring the placement head can be found in the SITEST online help
under Settings / Settings for the Twin Head. 2
Assembly instructions Head Reconfiguration SIPLACE D1 / D2
Edition 03/2007
74
2.8.2 Configuring the C&P head with SIPLACE Pro
: Go to 'Setup editor' —'Location'—'head tab' and enter the C&P placement head.
2
: Reoptimize the set-up in SIPLACE Pro.
2.8.3 Installing the nozzle changer
: To fit the nozzle changer, please read the Assembly instructions for the nozzle changer C+P-
Bestückkopf_SIPLACE_D1-D2 (00195370-).
2The nozzle changer for the P&P head must be configured as row 1the appropriate location. 2
For a D1S for a location without placement head, "none" must be entered for head type and noz-
zle changer. 2
2Risk of a head crash: Always run the placement heads with the appropriate nozzle changer.
The wrong nozzle changer causes a risk of a head crash. 2