196396 Iss 2 Nov 2015 - Semi Appendix Manual.pdf - 第32页
POWER UP SEQUENCE MACHINE POWE R UP SEQUE NCE Chapter Issue 4, Nov 14 Installation Manual 5.11 i. During the machine initiali sation, the followi ng window is displayed: j. Press the System button. Printhead Cov er Loop …
MACHINE PREPARATION
PRE POWER UP CHECKS
16.46 Installation Manual Chapter Issue 4, Nov 14
6. Ensure that all seven cables are secure and no bare wires are showing.
7. Connect the two probes of a digital volt meter (DVM) together and ensure
that the DVM is reading 0Ω.
8. Measure the resistance between the earth tag and all three isolator mount
securing screws ensuring that all measurements are less than 0.5Ω.
9. Remove the rear cover of the machine.
10. Measure the resistance between the following points ensuring that all
measurements are less than 0.5Ω:
a.PC earth stud and a securing screw that secures the PC to the machine
frame.
b.M36 earth stud and a securing screw that secures the M36 to the machine
frame.
c.M37 earth stud and a securing screw that secures the M37 to the machine
frame.
d.M39 earth stud and a securing screw that secures the M39 to the machine
frame.
e.M27 earth stud and a securing screw that secures the M27 to the machine
frame.
11. Refit the rear cover.
12. Refit the terminal cover.
13. Refit the mains isolator cover.
14. Refit the front cover.
POWER UP SEQUENCE
MACHINE POWER UP SEQUENCE
Chapter Issue 4, Nov 14 Installation Manual 5.11
i. During the machine initialisation, the following window is displayed:
j. Press the System button.
Printhead Cover
Loop & EMO
Operation
3. Carry out the following procedure for printhead cover loop & EMO operation
check:
a. Press the EMO button.
b. Reset the EMO by turning the button clockwise until it unlatches.
c. Press the Start button to restore electrical and pnuematic power to the
machine.
d. Press the System button when prompted.
e. Open the front printhead cover. The Machine Operation Suspended -
Cover Open window is displayed.
f. Close the front printhead cover.
g. Press the System button when prompted.
System Initialisation
DEK
Press the System button on the outer cover, to initialise the machine,
OR...
Select Diagnostics - to enter the machine’s diagnostic functions,
OR...
If the current product file needs to be changed, select Load Product to load another product file.
Diagnostics Load
Product Name
Product ID
Appendix to Micron Technical Manuals
APPENDIX C
Technical Reference
Information