196396 Iss 2 Nov 2015 - Semi Appendix Manual.pdf - 第92页

PREVENTIVE MAINTENANCE MONTHLY MAINTENANCE Chapter Issue 5, Aug 14 Technical Reference Manual 28.31 SEMI Level ProFlow (if fitted) Tick Inspect wiring/connections and pneumatics. Clean the attachment spindles , apply a w…

100%1 / 140
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
28.30 Technical Reference Manual Chapter Issue 5, Aug 14
Monthly Hardware Check
SEMI Level Machine Safety Tick
Examine the condition of the mains input lead.
Check all earth leads and bonding points are connected.
Check operation of the cover interlock.
Check operation of the Emergency Machine Off button.
Toggle all beacon lights.
SEMI Level Pneumatics Tick
Check air pressure switch is set to 3 bar.
Check the air inlet regulator is set to 4.5 bar.
Check pipes for air leaks.
Check and empty the air line water trap.
SEMI Level Rising Table Tick
Inspect the condition of the rising table drive belt.
Check for correct operation of the table brake.
Cycle the table, ensure smooth running, no looms fouled.
Check the critical home setting.
Check the vision height of the table.
Check the print height of the table.
SEMI Level Paste Dispenser (if fitted) Tick
Inspect wiring/connections and pneumatics.
Check the vanes do not foul the sensors.
Check the linear bearing guides for contamination.
Cycle the carriage, ensure smooth operation.
Check the carriage up and down sensors operate correctly.
Check the paste dispense movement on the linear bearing.
Check the critical home dimension.
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
Chapter Issue 5, Aug 14 Technical Reference Manual 28.31
SEMI Level ProFlow (if fitted) Tick
Inspect wiring/connections and pneumatics.
Clean the attachment spindles, apply a wipe of light oil.
Check the pressure mechanism operates smoothly.
Check the pressure mechanisms are secure when raised.
Check the operation and setting of the paste low sensor.
Estimated time required for Monthly tasks 4.0 hours
Summary/Remarks
Signed: Date:
PREVENTIVE MAINTENANCE
MONTHLY MAINTENANCE
28.32 Technical Reference Manual Chapter Issue 5, Aug 14
Month June Maintenance Procedure
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
WARNING
HARMFUL SUBSTANCES. CLEANING WIPES AND CLEANING SOLUTIONS MAY
CONTAIN SUBSTANCES HAZARDOUS TO HEALTH. OBSERVE ALL
MANUFACTURERS’ HEALTH AND SAFETY GUIDELINES. ALWAYS WEAR
APPROVED PROTECTIVE CLOTHING WHEN CLEANING THE MACHINE.
MANDATORY
TOXIC CHEMICALS MAY BE PRESENT. SAFETY GLOVES MUST BE WORN.
MANDATORY
TOXIC CHEMICALS MAY BE PRESENT. EYE PROTECTION MUST BE WORN.
SPC Alignment
Check and Machine
Cycle Count
Fill out details: SPC Alignment Check and Machine Cycle Count at the start of
this section.
Software
SEMI Level Software Check Record Tick
Check the date and time settings.
Check the software loaded and options.
Check the software version is the latest issue.
SEMI Level View Event Log Tick
Check for initialisation errors.
Check for screen position errors (31210, 31211, 31212).
Check for camera errors (31207, 31208).